If the Vaultz lock box has a combination lock, you need the combination to open and/or reset it. If it has an actual key lock, one can be ordered from the company.
Santa has a key that will open any door.
a diary
There's usually a small hole in the middle of the knob. You use a nail to push the lock back. Well.....you could just turn the doorknob and open it. You might want to rephrase your question.
true
Just like any other key ... except that a master key will open more than one lock.
You have to have a combination. If you have a key lock you don't need a combination, all it is is a lock that says master and a key to turn it and then it opens what you have in it.
A locksmith will be able to provide the combination from the code number stamped on the back of the lock.
master key on volkswagen golf 1997 wont open the doors
A key, or a Combonation
there are some keys out there... Sorry, absolutely not.
Lock smith! They can either open the door or make you a duplicate key (no master key needed).
I came across this problem. There is a lock below the steering wheel that will cause the trunk lever to disengage when it is pushed in. Use the master key to turn the lock (located below the steering wheel). It must be the master key. Without the master key you will need to remove the lock (located below the steering wheel). Good luck.
Master Lock offers a variety of padlocks, U-locks and combination locks. The standard way to open the Master Lock is to insert a key into the keyhole and turn it as you would any other lock. However, it's also possible for you to break open a Master Lock if you don't have the key. This method is good if you need to open the lock quickly, and picking the lock would take too long.Follows these instructions to open a master lock withou a key :1. Cut the metal loop off the lock with bolt cutters. Place the bolt cutters around the loop of the lock and apply pressure until the cutters break through the loop.2. Break a Master Lock U-lock with a hammer. Hit the loop of the lock directly at the curved portion of the loop. By hitting the right spot, the loop can be released from the body of the lock. This may take a few attempts to find the right spot.3. Break a combination lock with a screwdriver or shim. Pry the numerical dial off the front of the combination lock. Slip the screwdriver or shim under the numerical front and apply upward pressure. Break the center metal piece of the lock. Stick the screwdriver or shim in the hole on the front of the lock and move it around until the metal piece is loose and the loop of the lock releases.
You can open a key lock on a door knob, or you can open a deadbolt lock on the door itself.
Lock cylinders can be designed in a series so that one "master" key will open them all, but their individual keys will not open each other. Some manufacturers release sets of master keys to locksmiths, that can be tried on locks in the hope that one will fit. There is no single master key that will open all locks of a given make.
A donkey, monkey, turkey, piano key, keychain, or Key West. It's a play on the word key.