yes
I used Westech Aerosol HSEA glue to attach the side mirror back to the car. First make sure that the surfaces are clean, dry and free of dust. Then, spray the HSEA until it dries up. I am very impressed with this product and I recommend this to my friends. My friends also have positive experiences with this product as well as Westech Aerosol customer service.
Begin by removing the inside door panel. Connect the mirror with the mirror retaining bolts. Attach the mirror wiring harness.
Yes
On the driver side mirror adjust turn the adjust knob clockwise and that will allow you to adjust the driver side mirror. Turn the adjust knob back counterclockwise for the driver side mirroradjust
A concave mirror would focus the light back towards the focal point of the mirror. You would not be able to use the mirror effectively with a concave.
Epoxy is best. -J B Weld or Araldite.
When you refer to a 200 amp welder you are talking about the output side of the welder. What you have to do is find out what the input voltage and current of the welder is to calculate the size of a generator needed to operate the welder.
very carefully
If light hits a mirror at an angle it reflects back at you but it will make the image look bigger or smaller (if the mirror is concave or convex). If it is a flat plane mirror the image is the same but if your holding something it will be on the opposite side
with super glue stick it back on
Simply push the mirror back onto the ball joint.
First you need to remove the door skin , once this is removed you should see three screws that attach the mirror, remove them....if it is a heated mirror you will need to unplug and replug the new one in before attaching the new mirror...hope this helps