0
An impedance matching device is used to test the resistance, inductive reactant and capacitive reactant in a circuit. If one component did not match the impedance of the conductor, some of the current will be lost by the conductors itself. In conclusion if electricity is lost, the component needs to meet its regular voltage. It consumes more voltage than expected because of the loss. Impedance matching device can actually reduce electrical cost.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why impedance matching are important in communication circuit?
to reduce reflection loss from the load
What is the purpose of having a low impedance for transmission lines?
in order to reduce the transmission line losses we need low impedance...Low impedance also improves power transfer capacity of the line..
What is s device that interferes with the flow of an electrical charge?
You cannot 'slow' the flow of current in a wire. What you can do, however, is to reduce its value, or to limit its upper value. The device that will do this is a resistor. If, by your question, you are asking how to reduce the rate of change in its magnitude, then you can use an inductor.
What is reduction in electric consumption?
It is the reduction of using electrical devices. Each device is rated in watts. Cutting back on the use of these devices will reduce the watt consumption that is metered at the utility meter. The reduction of electrical wattage consumption will result in a savings of money to you.
What is the Difference between low and high impedance relays?
It depends on the resistance level in that area if the soil have low resistance then they will use high impedance system and vice versa..so reason behind this have to reduce fault current.
What is the purpose of safety device?
The purpose of a safety device is to reduce the danger of injury.
What is characteristics impedance?
The characteristic impedance or surge impedance belongs to a uniform transmission line, usually written Z0. It is the ratio of the amplitudes of a single pair of voltage and current waves propagating along the line in the absence of reflections.
Characteristics of electrical communications'?
to reduce the time
Why short circuit calculation is not required for LT cables?
Lt cables has own impedance which reduce the short circuit fault level
What is primary reactor?
This item is normally seen in electrical switch gear (or called "Starter "/ "Motor drive") . This device is to reduce the inrush current during motor starting. Another item "Line reactor" .
What is a rumble device designed to?
The rumble device is designed to - encourage you to reduce your speed - alert you of a hazard approaching
How can you reduce getting electrical shocks?
Don't use the drugs
