Its a bad practice to get into. You should also have them on the ground when you dismount the vehicle.
That is up to your employer.
You raise and lower the forklift with the left analog button
No, the fulcrum point on a forklift is typically the front wheels, while the center of gravity is higher up near the load. This arrangement allows the forklift to balance and lift loads efficiently.
Always down and on the floor.
A forklift mast is the column up which the two blades move up and down to lift and lower a load on a pallet.
Press any button while the error code is displayed in order to display the cause of the malfunction. You will end up calling the service department to come look at your forklift.
Forklift.
It depends on the model and serial # of your forklift. A YAM forklift is like asking for the specs on a Ford. Need all the info you can find on the lift and the engine.
Pushing a forklift up a ramp is quite unsafe. Much better to place them back to back and connect a strong chain to a secure point on both vehicles and tow it up, with the tow vehicle going forward and the disabled vehicle in reverse.
Vertical is up and down while horizontal is left and right.
The vertical frame in front that extends up.
it makes you fall over if you run while saying 'If up is down then left and right'