answersLogoWhite

0

No, the output of most DVD players are analog stereo (front channel only) or digital optical or coaxial. The DVD player must be connected to a surround sound receiver, and then the front and rear speakers can be connected to that.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you connect inspire t6160 speaker system to tv?

Connect the green 1/8" stereo cable out of the T6160 to the audio output of the TV. If your TV has a headphone or 1/8" line output, you can use that jack. Otherwise, you will need a RCA adapter. Since you TV won't have a surround output jacks, you will only be able to use the front speakers and subwoofer.


Does a car dvd player connect to the car speakers?

They can,but it's not necessary.Since the front passenger and driver can't use the dvd player they will want to hear the stereo.Therefore the dvd player usually uses headphones.


How do you connect your speakers and sub to your amp?

You connect speakers and a sub to an amp by placing each wire into the appropriate connector. The connectors on the side of the amp are labelled for front, back, side, and sub depending on the configuration.


I upgraded the factory speakers. Why are my front speakers louder than the rear speakers?

Check your EQ System, (The CD player) if the balance is in the middle


What home speaker system by sony has 16 normal speakers 2 front speakers and 2 subspeakers?

That would make a total of 20 speakers. Sony sells no such system, nor do they sell an amplifier that can connect that many speakers.


Can I connect two 2 ohm speakers to the front channels of my amp and then connect 2 4 ohm speakers to the rear channels of my 4 channel amp?

This depends on your amplifier's specifications. i would recommend looking in the amplifier's service manual to avoid disapointment or damage to your amplifier or speakers.


Is a screen an input or output?

Output. Even if the screen is a touchscreen, the screen itself is still output. The input is handled through a conductive layer on top of the screen, ultrasonic waves in front of the screen, or from an electrostatic field in front of the screen and not from the screen itself.


How do you install speakers into a packard bell PC?

To install speakers into a Packard Bell PC, first ensure the computer is turned off and unplugged. Connect the speaker cables to the appropriate audio output port on the back or front of the PC, usually marked with a headphone or speaker icon. Once connected, power on the PC and adjust the audio settings as needed to ensure the speakers are recognized and functioning. Finally, test the speakers with audio playback to confirm proper installation.


My radio keep shorting out when i connect my front speaker wires on my 92 park avenue?

your wires maybe touching or the speakers are blown


Can you connect a 5.1 speaker system as you have three sound ports?

Yes, you can connect a 5.1 speaker system using three sound ports, but it depends on the type of ports and the configuration of your audio system. Typically, a 5.1 system requires specific connections for front left, front right, center, subwoofer, and surround speakers. If your device has a dedicated 5.1 output or can use an adapter or receiver, you can achieve the desired surround sound. Otherwise, you may need additional hardware or an audio interface that supports multichannel output.


Where do speaker connectors go on a MacBook Pro?

Researching the Macbook Pro has shown that the speakers port is available. One can use the headphones port located on the left front of the Macbook to connect speakers.


What size are the front speakers on a 1992 passat?

Front (in dash) speakers are 4"