0
What else can I help you with?
What is the function of a power plant in a city?
The supply of power to that city.
What would keep the 4 by 4 buttons from lighting up?
Disconnect them from any power supply!
How do you supply power to your whole city in simcity ds?
Pug
What are the effects of poor power supply on students performance in Nigeria?
It is difficult for students to learn without proper lighting and ventilation.
Why 440 volt for motor and 220 volt for lighting?
The higher the voltage, the less amperage is required and is easier to supply power to the device. Motors take much more power than lighting, therefore voltages may be higher for easier transmission.
How do you change back to stock head lights from HID lights lpaced by previous owner?
As long as it is a conversion kit, and not a replacement headlamp unit, it should be straightforward.Purchase standard halogen bulbs of the correct fitting for your vehicleRemove ballast unit that is connected to the HID bulbs. In most cases, they are powered only from the lighting power supply. Disconnect the cables to the bulbs and to the lighting power supply.In some cases there may be an additional power supply from the battery to the ballast. This can also be removedRemove HID bulbs from the holdersInsert replacement Halogen bulbsThe lighting power supply should connect directly to the new bulbsIf the power supply does not connect, the holders or wiring may have been modified, and replacements would need purchased.
How many terminals does a two way lighting switch have?
A two-way lighting switch typically has 4 terminals: two terminals for the switched circuit and two terminals for the incoming power supply.
What is the load side?
When discussing electricity it is common to break into two parts. There is the supply side which is where the power exists and the load side where the work gets done. In a lighting the supply side would be your house power, for example; and the load would be the bulb. In a flashlight the supply is the battery and the load is the bulb.
Where can one shop for a mirror ball?
Mirror balls, or disco balls, can be purchased at party supply stores such as Party City. They are also available at DJ supply stores and specialty lighting stores.
Can 220V 50Hz lighting fittings be used on 220V 60Hz power supply?
Yes. the voltages will be compatible. Though in North America it will probably be hard to find 220 volt rated lighting fittings as the common voltage rating for lighting fixtures is 120 volts.
Where can I find theatrical lighting rental in Kansas City?
A and Z Theatrical Supply rental will rent theatrical lighting and many other things. They are located at 307 West 80th Street Kansas City, MO 64114-2376. Here is the website to get you started: http://atoztheatrical.com/catalog/.
How can you connect single phase generator in three phase supply system in house lighting system?
First house lighting systems are single phase not three phase. To connect a generator to the house lighting system for emergency power, it would take an electrician to do the job properly. The biggest concern would be to isolate the rest of the service from the main distribution supply service and then isolate the rest of the distribution panel loads from the lighting loads.
