Yes, it can damage every moving part in the engine.
Get New piston rings!
Low oil pressure Low cylinder pressure Anti freeze coming out of the tailpipe (sickly sweet smell) Water in oil Oil in water Frothing or bubbling in radiator
If you've run with the "low Oil" light on, there ISengine damage, the question becomes, "how much?"Check the oil pressure. If the oil pressure is down that's pretty severe engine damage.You won't be able to check the cylinder wear without pulling a head, but most likely, poor maintenance will result in excessive cylinder wear.
A "Bad cylinder" or "dead cylinder" is a cylinder with Low compression psi. Symptoms: rough running low power can cause high oil consumption
An oil leak between the cylinder head and the engine block in your 2008 Opel Corsa Utility 1.7 TD could be due to a few reasons, most commonly a failing head gasket. Over time, the gasket can degrade, allowing oil to escape from the engine. Other potential causes may include warped cylinder heads or loose bolts that have not maintained proper torque. It's advisable to have the issue inspected by a mechanic to prevent further engine damage.
No there is not a sensor to keep it from starting if the oil is low
A tapping noise in a Corsa 1.2 SXi could be indicative of several issues, such as a loose or damaged timing belt, worn engine components like lifters or valves, or even low oil levels affecting lubrication. It's important to check the oil level first, as low oil can lead to increased engine noise. If the noise persists, it’s advisable to have a mechanic inspect the vehicle to prevent potential damage. Regular maintenance can help identify and address issues early on.
Clogged filter, low oil, thin oil, worn out engine.
To prevent damage to the engine in case the oil level gets too low.
For a three-cylinder Vauxhall Corsa, it's typically recommended to use a fully synthetic engine oil with a viscosity rating of 5W-30 or 0W-30, depending on the specific engine and climate conditions. Always check the owner’s manual or consult with a professional for the exact specifications required for your model year. Additionally, ensure the oil meets the necessary API or ACEA standards for optimal performance.
low oil pressure could be bad bearings or stuck relief valve
this is indicated on the dipstick there are two marks low and obviously full have it just to the top mark leveled with a line or in writing do not over fill otherwise you will cause damage to the enging that's basically it.