Moving coil galvanometer is used to detect unknown resitance of the both ac or dc circuits :)
deepak instrumentation engineer
AnswerA 'galvanometer' is simply an instrument that detects and measures small currents; 'moving coil' describes its operating principle. A moving-coil galvanometer is a d.c. instrument; if subject to a.c., then it will simply vibrate as it will not be able to respond the the frequency (unless the frequency is very low, in which case, it will sweep back and forth in step with that frequency).
The moving-coil principle is applied to other instruments, and can be used in the construction of multimeters. In the case of a multimeter, a rectifier circuit is incorporated so that it can be used to measure a.c. currents and voltages.
to reduce the flow of current & keeping the current through galvanometer within safe limits.
Too much current for the rating of the bulb.
A series circuit is a circuit that only has one path for current to flow on, a parallel circuit is a circuit that has multiple paths for current to flow on. Parallel circuits are mostly used, especially in your house/home. The reason of that is because, if a device in a series circuit electrically malfuctions or goes down, it will stop the current flow, thus ending and cuting the whole rest of the circuit. In a Parallel circuit, if a device electrically goes down, current will still be able to flow through the other circuit branches, and the rest of the circuit, thus keeping electricity flowing.
The transformer can be tested on open and short circuit to find the iron losses and copper losses separately, which uses a fraction of the power than having to run the transformer on full-load.
For any appliance or lamp to operate at its rated power, it must be subjected to its rated voltage. Every branch of a parallel circuit is subjected to the same (supply) voltage. This is the main reason; the secondary reason is that any break in a series circuit will de-energise all the appliances connected to it!
Absolutely not. The reason behind is that it shows currents (both ac and dc) which has a desired direction of flow of electrons.. So Galvanometer does not have any electrolytic terminals!!
to reduce the flow of current & keeping the current through galvanometer within safe limits.
For the same reason any animal has a nose ! Do detect smells !
Submarines have sonars.
In general, he doesn't. The reason being because he is deaf.
In series with the circuit and never in parallel. The reason being that it will cause the circuit total resistance to drop which will make the circuit draw excessive current. That's a short circuit actually.
for some reason, they just distort the circuit.
Sonar. Active and passive
To detect problems with the core shifting or grounding problems
sound wavers are affected by propellers
You can't detect this, nor do you have any reason to.You have to communicate with the child. However, in most cases, it's probably best to wait until the child comes to you to talk about it.
There are various reasons that people are moving out of Brazil. A big reason is the fact that the government is corrupt.