When installing things like shower doors, although you can do it yourself, I would suggest getting the help of a professional. This is because you want to be sure that it has been installed securely, and they will have more experience than you in installing it.
it could be a number of things, premixed thinset, to much flex in the substrate, mixed thinset too thin, didnt seal grout "if in shower" where is the tile installed, what did you use to install it and how did you install it?
To take a shower is US English; to have a shower is UK English.So they are both correct.
You Can but typically the pipe for the shower head that is coming out of the wall is just a short piece of pipe that you should be able to remove easily enough by unscrewing it. Then you can just replace that piece with a new one. == Answer== Do the same as above but make sure your shower arm is not floppy, if it is you could tear up the riser coming to the arm. Be very carefull.
That is the handles, screws, face plate and everything except the rough in valve. The rough in is the main body of the valve that is installed in the wall before drywalling or putting the tub/shower in. The trim is put on after the walls are finished.
By hand with a hammer and chisel.
The tools that are needed to install a bathroom shower are measuring tape, spanners, tile drill, dust sheets, pencil, and pipe cutters. It is best to engage a professional shower fitter to fit one's bathroom shower, instead of DIY project.
Walk in shower stalls are moderately difficult to install. Pre fab shower stalls are already built for you and only need to be installed. Unless you are an expert it is highly recommended to hire a licensed plumber to get the plumbing set up before installing your shower.
Call a professional so someone does not get scalded
The Bobrick shower curtain cannot be installed in the ceiling. It is made be installed in the shower wall brackets.
Because these shower rods are customizable for length, they can be installed into any standard shower.
Prices for walk-in shower/tubs vary. Usually they need to be installed by a professional so that will make the cost a little higher. This site http://envywalkintubs.com/ has them starting at $1899 which is not a bad price.
Get a professional to do it.
The cost to have a shower tray installed ill depend on the type of tray you choose. You can expect to pay about $20 per hoor for the labor.
There are a lot of shower installations out there that were done in a time when efficiency was not the order of the day. Because of this, many showers out there use way too much water, and allow way too much water to spill out of shower doors. Generally, if your shower was installed before you bought your home then you may want to consider getting a new shower installed. If you rent, ask how old the shower is and see if you can work something out with your landlord to have a new one installed. Old showers can also hold serious levels of mold, so be careful.
You can't shower without getting wet, unless you are taking an imaginary shower. The whole point of a shower is to get clean, which you can't do without water.
Installing a steam shower in the basement is not a good idea. The steam shower should be installed in the nbathroom of your home.
Because someone installed a really cheap one