0
Yes, the clockspring is part of the wiring of the airbag system. A faulty clockspring could keep the airbag from functioning.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Is it unsafe to drive with a malfunctioning clock spring?
I have a vehicle which had a recall for clock spring trouble. There were no mechanical issues which disrupted the vehicles performance while driving. However, the air bag light stayed on until the repair was done. This apparently means the air bag was not functioning as designed. So the problem is one of safety in a collision event where airbags would be deployed.
Gmc jimmy air bag clock spring how to replace it?
The clockspring is replaced by removing the airbag, and by removing the steering wheel. From there disconnect the old clock spring, and put in the new clock spring, and replace everything in reverse order.
If the horn doesn't work and it is not the fuse then what could it be I have a 2001 Ford F-150?
Could be what they call the clock spring if you have an air bag i don't suggest you do it ! The air back system and the clock spring are fragile.
What is a Clock Switch?
I thnk you mean a clock spring. It is located underneath the airbag in the steering column. It has to do with the air bag and such.
Would a bad clock spring make your horn not work?
If the steering wheel clock spring is broken both your horn and air bag will not work and can possibly malfunction.
How do you repair horn clock spring 2002 Mercury Mountaineer?
Usually, there is no repairing a clock spring. Normally, if there is an issue a person replaces it. It is replaced by remove the air bad and steering wheel, then removing the old clock spring and putting a new one.
Why does your air bag light stay on in your 1998 Malibu and it will not pass inspection if it will not turn off?
Under yhe horn pad/air bag on the steering wheel is what that is referred to as a clock spring. The most likely cause for the light is that the clock spring is defective.
Will the clock spring on a ford explorer make the air bag light stay on?
yes, sure can.
How do you install an automobile clock spring?
Changing a clock spring is not a job for a novice. you need to remove the air bag then the steering wheel then you can see the clock spring. next you need to remove the steering column cover which is easier if you unbolt the column and lower it. This will give you access to the wiring connections. Good luck
Is horn connected to airbag light?
Yes , in a way. The connection goes through the clock spring just the same as the air bag module. Pre air bag cars used a horn brush but newer car's w/air bag's need a more sokid connection, thus the inception of the clock spring. It allows the air bag to remain "hard wired" at all times, unless of course the clock spring breaks. I allows constant connection while the steering wheel is being turned. Abroken clock spring will set a code in the SRS (air bag system) and turn on the air bag light meaning the system has been disabled because of a malfunction.
How do you replace clock spring on a 05 Dodge Magnum?
Give it to the professionals to do, it requires disassembling the air bag.
Where is the location of the clock spring in the car?
A clock spring is in the steering column and acts as a rotating connection so things like the horn, air bag etc will work in any position as the steering wheel rotates. If you look at the base of the steering wheel there are usually a couple bolts or screws that hold on the column cover if you remove it you may be able to see the clock spring, however removing it is much more involved! If you need to replace the clock spring it is usually advised to have a mechanic do it because of the air bag!
