0
Yes, and it can also whine if the fuel filter is partially clogged.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why do new tires whine?
Only aggressive tread new tires whine.
What are the release dates for Lois and Clark The New Adventures of Superman - 1993 Whine Whine Whine 2-21?
Lois and Clark The New Adventures of Superman - 1993 Whine Whine Whine 2-21 was released on: USA: 14 May 1995
Citroen berlingo 1.9d new water pump fitted why car is over heating?
the head gasket needs replaced.
Mazda 6 won't idle New pump been fitted Still stalling Any ideas?
I had the same prob, turns out it was a vac hose that needed to be replaced not the fuel pump
How do you fix a faulty fuel gauge a new pump fitted?
if gauge worked prior to pump change then you will need to remove tank & check wiring & condition of sending unit, they are easy to mess up putting pump down in tank. if it didnt work prior to pump change then replace sending unit.
What is the problem when a 04 rm 250 leaks water from a small hole below the water pump?
you need a new water pump seal. also check to see if the shaft is worn might need to replace that too you need a new water pump
How do you replace the water pump on the 1995 Chrysler new yorker?
Difficult operation remove large flat plate covering serpentine belt. water pump is driven by that belt. 3 screws hold the pump in place. Replacement pump has to be properly fitted with o rings. Replacing the belt must be done properly so as not to disturb timing. Dealer cost me $700
No compression but new timing belt why?
If everything was fine before the new belt was fitted then the most obvious answer is that the timing belt has been fitted incorrectly and the timing is wrong.
Why overheat my 2.4 diesel hilux bakkie after i fitted a new water pump as well as to check the thermostat?
Try flushing the heating sysem out your heater core may be blocked or your coolent might be getting old
How do I change 1985 Chrysler new yorker fuel pump?
the pump is in your fuel tank to take the straps down you will need a 18 mm deepwell socket and a flat screwdriver and a small hammer for fuel pump removal
When you turn the key nothing happens not even a click New battery fitted new starter motor fitted Electrical problem any ideas?
Possibly the ignition switch is defective.
Why is vehicle not starting after putting new fuel pump on a 98 windstar?
Could be fuse could be fuel line not reconnected good and sucking air. Turn the key to the run position but do not start have friend stand at gas filler door remove cap and listen for the high pitch whine of the pump. if you hear it look for leaks. if not check for connections and fuses
