answersLogoWhite

0

Yes. Its actually quite good for the starter motor.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you reverse a Holden barina?

To reverse a Holden Barina, first ensure the vehicle is in reverse gear by pressing down the clutch pedal and shifting the gear lever into the reverse position. Once in reverse, release the clutch gently while applying throttle as needed to reverse the vehicle smoothly. Use the mirrors and rearview camera (if available) to help guide you while reversing.


What is the poor habit of resting your foot on the clutch pedal while driving a stick-shift vehicle?

Answer: "Riding the clutch"


Is there a switch to allow ignition on the clutch or clutch pedal of a 1999 ford?

Yes, and I think that is actually a law. It prevents starting the vehicle while it is in gear, dangerous stuff.


What causes a vehicle's RPMs to rev up while driving?

If you accelerate and the transmission shifts to a lower gear of the overdrive disengages the RPMs will increase. If the vehicle has a manual transmission a slipping clutch will cause the RPMs to increase if the clutch is defective.


What is a function of the clutch in the vehicle?

The purpose of a clutch on a vehicle is to disconnect the drive of the engine from the gearbox (this would be required when the vehicle is stationary or to change gear). While the engine is running the crankshaft is continually turning, It is the crankshaft that turns the gearbox and via the gearbox the road wheels. Obviously there are times when the engine is running but drive is not required, The clutch is the mechanism by which this is achieved.


What would cause hesitation and loss of power while manually switching gears on a vehicle?

Adjust your clutch cable.


What are the roles of friction and gravity in the car?

Friction in cars are produced by the tires and the clutch. The friction caused by the tires allow the vehicle to stay on the road, while the friction produced by the clutch makes it possible for the car to get moving. While gravity, for example supplies the force that pulls the vehicle down the hill.


Why does your vehicle AC blow cold while driving and warm while idle?

Depending on the year, make and model check the cooling fans or fan clutch for proper operation...........


Is there a difference between holding the clutch down or putting the gear into neutral while standing in the traffic lite -In a technical manner?

Leaving your vehicle in first gear with the clutch depressed allows you to move out of the way quicker if you notice the vehicle behind you is not going to be able to stop before it hits you.


What are the basic steps for driving a manual car?

Driving a manual car involves several fundamental steps. Firstly, ensure the car is in neutral by pressing the clutch pedal and shifting the gear stick to the middle position. Start the engine and gradually press the clutch while shifting the gear stick into first gear. Slowly release the clutch while gently pressing the accelerator to start moving. To change gears, lift off the accelerator, press the clutch, shift to the desired gear, and then release the clutch while gradually applying the accelerator again. Rem


What is the main function of the ignition safety switch?

To prevent the engine from being started while the transmission is any gear other than park or neutral.


Why should you not apply the clutch when driving on a long steep downhill slope?

Applying the clutch while driving down a long steep slope can lead to a loss of control and increased wear on the vehicle's brakes. It disengages the engine from the wheels, removing engine braking, which is crucial for maintaining control and slowing down safely. This can result in overheating the brakes, reducing their effectiveness, and potentially leading to brake failure. Instead, it's better to use a lower gear to utilize engine braking effectively.