only if there is a serious engine problem. A boat motor is cooled by lake water instead of a radiator and coolant system. The lake water is pumped into the motor's cooling tubes and pumped out through the exhaust. The only way I can see that there would be water in the oil is if the motor has a blown head gasket or a cracked valve.
When you go on a river cruise, sit on the top deck of the boat if possible. This will give you the best view of the river, and it will not seem like the boat is moving in the water as much as it would be if you were sitting on the lower deck.
The boat may be sitting low in the water due to the combined weight of the two fishermen and any additional gear or equipment they have on board. The displacement of the water by the boat is determined by the weight of the boat and its contents, causing it to sit lower in the water when heavily loaded. It is important for the fishermen to ensure they are not exceeding the maximum weight capacity of the boat to maintain stability and safety on the water.
Boat engines circulate water through a heat exchange with the oil, so that might indicate a leak in the heat exchange coil.
This is true! the water can be going at ten miles /hour on one side and totally still on the other side of a ten foot boat with out a motor sitting in the ocean.If you want an explanation go to footrotfalts.blogspot.comThere is a Finish proverb. "the water is the same on both sides of the boat" It is wrong
If you have an oil leak in your boat, you are causing water pollution, which can harm marine ecosystems and wildlife. The leaked oil can create a film on the water's surface, reducing oxygen exchange and affecting aquatic life. Additionally, it may lead to legal consequences and damage your boat's reputation among environmental regulations. Prompt action to fix the leak and clean the spill is essential to mitigate these impacts.
Cracked block or blown head gasket.
oil spill is when a boat or something else spills oil in the water or in the forests.a lot of oil spills happen when people drill for oil or when there's a leak somewhere they keep oil.
you fill up one tube of the boat with water untill it comes out of the other tube. then you get the candle or oil lamp that you made and light it. then put it unbder the boiler and quickly put the boat in the water. after a few seconds, the boat will drive.
on a oil rig boat
Weight used to keep the boat stable in the water. Old seagoing vessels, such as pirate ships use to have ballast stone which was kept in the bottom of the boat down the middle(keel) to keep the boat sitting properly in the water. Modern submarines use saltwater in their ballast tanks(big huge tanks located inside the hull) to enable them to sink and remain submerged
To balance an eight, all the oars should be at the same handle height. Water pressure is key in balancing a boat, so if the boat is tilting to one side, that respective side should raise their oar handles, creating pressure on the water, lifting their side up. Also, sitting in the middle and keeping the limbs and such near the center will help balance the boat.
Do not use auto power steering oil in a boat.