yes.. water jet cutters are the strongest cutters apart from lasers and diamond tipped blades... they can cut through any solid except for diamonds, and some hard gems...
Yes. All endmills will cut on their periphery (sides), as well as their end. This is so because the endmill must be able to make their cut to a certain depth, thereby contacting the work partly on the side. If they weren't capable of cutting on the side, the side would simply rub the work, and the end wouldn't cut either. Some endmill work is done solely on the side of the cutter. Endmill cutters are specified by their diameter and their length. The length of the side cutting portion is called the 'length of cutter' (LOC).
hacksaw
-The drill press can take bits of up to 1/2 shank size and many of those are drill bits up to an inch wide. ( it's quite common to have large drills with reduced shanks) -Other items like large hole saws can be used, as well as 'fly cutters', which are cutting bits on the end of a movable beam. These can usually cut holes in thin materials like plexiglass sheet, up to a foot in diameter. Forstner bits up to 6 or 8 inch can be used, these cut large, flat bottomed holes for installing clocks and other instruments. Milling bits can be used to 'mill' large areas of rough surface to smoothness, and 'square hole tools' can also be used. The large drill press is a very versatile tool.
Punch
First, a round bar is cut to the correct length of the bolt. A hex head is then hot forged onto the end of the cut rod. Then, high speed blades are used to cut the correct threading onto the bolt.
Yes cheese block cutters can be used to cut cheese. Block cutters look a little like hacksaws and make cutting big blocks of cheese much easier.
Cable cutters are used for cutting cables. There are different sizes of cable cutters and different strengths possible. Some are strong enough to cut through twisted steel.
Side-cutters or diagonal cutting pliers should be used to cut wires, cables, and other materials where precision cuts are required. They have a cutting edge that is angled to provide a clean cut close to the surface.
Diamond is used to cut glass, since it is harder than glass.
A tube cutter or a pipe cutter is used to cut the pipes or tubes
Yes, limestone is attractive, easy to cut and shape, and water resistant.
cookie cutters. different shapes of metal to cut out cookies.
Diamond edged cutters are the most reliable, and are used in industry to accomplish this.
Router cutters are use to cut or saw any wood in any shape. People mainly use router cutters to fill up holes with wood that is custom-shaped using the router cutter.
Larger pieces are often cut and shaped at the quarry; however, smaller pieces are more typically cut and shaped at other facilities. Custom pieces are most often cut and shaped on the building sight.
It is used in the construction department for building and is cut out from the Maltese quarries
If you tried to cut a wire that is too hard, it will damage the cutters.