answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can we compare two different methods for measuring the mass of a rubber stopper?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you find the density of a glass stopper?

Find its mass using a beam balance,and volume by a measuring can full of water,and divide both to get volume


Why are the stoppers of vacutainer tubes color coded?

different colours represent different additive content (Ex. a red stopper shows there is no anticoagulant, while a lavender stopper indicates EDTA is present in the evacuated tube).


What is the density of rubber stopper?

The density of rubbers stoppers can be very different from one to the next. This is because there are different stoppers at different densities.


Is stopper or stoper spelled correctly?

it is stopper =]


What is a bleeding stopper?

Styptic pencil is a bleeding stopper.


When was The Crystal Stopper created?

The Crystal Stopper was created in 1912.


How tall is Janina Stopper?

Janina Stopper is 157 cm.


What is cook stopper?

A CORK stopper is a plug for a bottle made of cork


I have a beautiful glass globe hummingbird feeder that has a rubber stopper. How can I stop the nectar from leaking out of the stopper?

If there is debris on the stopper it might be preventing a good seal. Try removing the rubber stopper and wipe it off to remove any debris that might be on it. Clean out the hole that the stopper goes into as well. This will help ensure a clean seal between the hole and the stopper. Put the stopper back into the hole, making sure it is a tight fit. If it still leaks you may need to buy a new stopper.


How do you remove a push pull stopper from a tub drain when it has come loose?

On most push/pull stoppers the knob part that you pull on unscrews from the stopper, and under that is a slot for a screwdriver tighten or remove the stopper. On stoppers with non-removable knobs, there is a screw (usually phillips) under the stopper which can be accessed with the stopper in the up position and unscrewed to remove the stopper.


When was Juan Stopper Sanchez born?

Juan Stopper Sanchez was born in 1941.


When did Juan Stopper Sanchez die?

Juan Stopper Sanchez died in 1991.