Yes. You want to keep the coolant level between the min and max lines. Too much and it will overflow. Too little and you risk warping the heads or worse.
This tank can hold up to 134.65 gallons of water.
They didn't have a tank they filmed most of the movie in a swimming pool
Listed in order below (the crew of the Nebuchedezzer) Mouse Apoc Switch Dozer Cypher Tank
From the floor to the top of the tank
Fear Factor - 2001 Descender Jump Sheep's Eye Water Tank 1-7 was released on: USA: 23 July 2001
Just pour it into the coolant tank. Don't overfill, use 50% water and get an extra 15lb coolant tank cap.
Yes
.
I believe that you fill it with coolant, as the tank's name suggests.
There shouldn't be just water in the expansion tank. If the coolant (50% anti-freeze and water) appears to be boiling in the expansion tank, you may have a bad head gasket or cracked head.
The year, make and model vehicle would help and there shouldn't be just water, it should be coolant.
You don't "fill up" the water pump. The water pump is just a pump that moves coolant throughout the engine cooling system. You add coolant at the radiator or the coolant recovery tank.
Means your radiator (coolant) level is low (below the sensor in the tank--you can see it). Just keep the coolant above that and you'll be good.
1. raise gas tank, the radiator cap is there, below the gas tank, open the cap... 2. remove the drain bolt on the water pump cover and drain the system coolant.. 3. disconnect the hose from the reserve coolant tank, end empty the coolant from the reserve tank, and after that connect the hose . 4. re install the drain bolt n fill the coolant from radiator cap, the drain bolt potitions on left side under the engine.
below the coolant tank in a black cover.
Hot water (engine coolant) expands and pushes its way back into the coolant reservoir.
In radiator or through coolant recovery tank