0
What else can I help you with?
Where exactly is the location of your oxygen sensor heater in a 2002 rodeo?
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
Where did you buy the oxygen sensor?
An O2 sensor can be purchased at any auto parts store.
How do you fix oxygen sensor threads?
You need to get a die that fits. Probably cheaper to buy the sensor
Will a faulty oxygen sensor make to car spell like gas?
A faulty oxygen sensor can make a car smell like gas. Oxygen and gasoline mixing wrong can cause excessive pollution. Replacing the oxygen sensor can correct this issue, and improve the gas mileage in the car.
Where is oxygen sensor on 1987 Dodge Aries?
If you follow the exhaust pipe out from the back of the engine you will see a cable going to the oxygen sensor in the exhaust pipe. You will need a special type of socket to remove the oxygen sensor which you can buy at an auto parts store.
How do you replace a front oxygen sensor bank 1 sensor 1 code 135 in a 2004 Chevrolet Impala LS?
It requires a special socket and it is only good for oxygen sensor replacement. Buy the socket and unplug the sensor ,install the socket and remove the sensor.
How can an oxygen sensor affect the performance of a 1988 ford ranger?
sending wrong fuel ratio mix
Where is the locations of oxygen sensor for Mitsubishi Outlander?
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Do you need a oxygen sensor for headers?
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
Ford Fiesta oxygen sensor replacement?
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
Change oxygen sensor on 95 Oldsmobile cutlass ciera?
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
How do you change oxygen sensor on vw golf mk4?
Buy an oxygen sensor, some antiseize compound, and a sensor wrench. Unplug the wire from the car. Unscrew the old sensor. Put a little antiseize compound only on the sensor threads, Screw it in hand tight plus a half turn more, plug it in and you're done.
