0
Yes you can its very simple just connect the two pipes going into the valve together
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
The heater on your ford puma 1.7 blows cold when you want it hot is this a big job to fix?
Make sure your antifreeze levels are adequate (if it is too low, then there will not be enough hot antifreeze to flow through the heater core to make ther air warm.) I had this problem in my blazer and it fixed it right away. If that does not work, your heater core could be bad and a new one cost between 40-100 dollars and installation would probably be about the same. my ford puma has the same problem, i was losing coolant through the heater control valve on the bulkhead of the car so had to temp bypass it but if the valve stops working or the plug comes adrift it will stop warm water getting into the heater system in the car so i would check the heater control valve. you can buy them from eBay for about £12.
When was Ford Puma created?
Ford Puma was created in 1997.
Where is the PCV valve on a ford puma?
i have a 1.4 puma,i think its between inlet maifold pipes,there should be 2 hoses going into manifold and 1 in the middle going to the valve the hoses join on a T shape,my hoses collapse when engines running and kicks out black smoke
Where do you add transmission oil to a ford puma?
where is the gear box oil on a ford puma 1.7
Where is the temperature sender unit on a ford puma?
where is the water temperature sender unit on a ford puma
Where is the location of fuel pump relay 2001 ford puma?
Where is the fuel pump relay on a ford puma
Where is the crankshaft sensor on a ford puma?
In the trunk.
Ford puma thermostat housing?
The Ford puma thermostat housing is on the side of the engine, with two hoses connected to it. Be sure to replace the gasket when installing the housing.
Where can you get diagrams of a ford puma 1.7 engine?
anywhere?
How do you remove the exhaust from a ford puma?
with hands and tools...
Can you put the back seat down in a ford puma?
No ..
No heat in ford puma?
I am on my third heat control valve, it is a known fault; when you purchase replace ment make sure that you buy the latest batch. the valve is accessed from the engine bay and is found by the wiper assembly. It looks like an "H" Good luck
