yes, it works just as good as shining your shoes.
I haven't seen vinegar clean jewelry but I saw my girlfriend clean my tarnished earrings with toothpaste. I was amazed.
lemon juice.
For platinum or gold, use Mr. Clean, water, and ammonia. This is what jewelers use in their ultra sonic to clean jewelry and is safe for all types of jewelry. Half Mr. Clean and water with just a little ammonia. Sterling jewelry is cleaned using either a sterling jewelry dip or baking soda and water as a paste. I would not use toothpaste. Toothpaste is abrasive and can ruin a high polish.
yes, you can, it won't make a difference.
Oxy Clean may be OK to clean just the diamond, but I wouldn't use it on a piece of jewelry. A home cleaning solution that is used in many jewelry stores is Mr. Clean and water with a small amount of ammonia. I will add a resource link to how to do this.
use rubbing achohol and clean the scratches
try to clean it with peroxcide no achohol it might be infected so you should just go see your docter
I haven't seen vinegar clean jewelry but I saw my girlfriend clean my tarnished earrings with toothpaste. I was amazed.
Clean your jewelry with isopropyl alcohol, or at least 80% cleaning alcohol if you have that.
put it in a container full of rubing alchol and salt and shake it (not hard) and use a pipe cleaner for the rest
Achohol is a depressant which slows you down. Also, goes directly to your bloodstream and can increase risk of diseases.
A solution of half Mr. Clean and water with a small amount of ammonia can be used to clean gold jewelry. This same solution is used in the ultrasonics of many jewelry stores including chain jewelry stores. I will add a link to a full article about cleaning fine jewelry.
"HGF" or hollow gold filled jewelry is considered a fine jewelry and should be treated with the same caution when cleaning. To clean HGF jewelry a solution of Mr. clean, water, and ammonia can be used. Mix half Mr. Clean and water with a small amount of ammonia. This is safe for all types of fine jewelry and is used by many jewelry stores. Allow the jewelry piece to soak for 15 seconds in this solution then rinse with water and dry.
Yes.
The Da Vinci Jewelry I know of is considered fine jewelry and since fine jewelry needs special care I will explain how to clean fine jewelry which will be good for all types of jewelry. A solution of half Mr. Clean and water with a small amount of ammonia can be used to clean all types of fine jewelry. Soak the jewelry piece for 15 seconds then rinse in cold water and dry. This solution is used by many jewelry stores I know of and they use it for all types of jewelry including inexpensive jewelry, fine jewelry, and even opals, and emeralds. A bowl can be used, but an ultrasonic is better. Repeat if the piece is extra dirty.
You have to remove the jewelry and clean it, including the piercing.
Always make sure to clean both your jewelry and the piercings themselves with hydrogen peroxide to avoid infection. Store your jewelry in a safe and clean location. Never purchase plated jewelry.