answersLogoWhite

0

No, you cannot disconnect the Power Distribution Center (PDC) on a 2008 BMW 750Li simply by pulling a fuse. The PDC is responsible for distributing power to various electrical systems in the vehicle, and removing a fuse may not effectively isolate the PDC. To properly disconnect it, you would typically need to disconnect the battery or follow specific procedures outlined in the service manual. Always consult the manual for the correct method to ensure safety and avoid damage.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Change fuse bmw 750li?

To change a fuse in a bmw 750li first locate the fuse box either near the trunk or glove box. There should be a diagram with the box telling you which fuse is which. Remove the desired fuse and replace with a new one.


How do you disconnect alarm in your 93 q45 Infiniti?

Pulling the fuse and/or relay does not work. Still troubleshooting to figure out. Will post when known.


How do you disconnect the horn on a Ford Escape 2005?

well you can start by pulling the fuse out for the horn or in the front under the hood near the radiator u can unplug the conecter . Tried that, didn't disconnect the horn.


Where is check engine reset button on 1991 Suzuki Sidekick?

pull dome fuse above knee. in fuse box. pulling battery makes ecu relearn everything. dome fuse resets memory only. Maybe just disconnect battery for a couple of minutes and it will reset


How do you disconnect your washer fluid fuse?

Identify the fuse. Remove it


Will pulling the airbag fuse disable it on 1997 Buick century?

yes. but fuse no 31 goes to the front pass airbag. The front driver may have to go through a different more complex procedure. But remember to disconnect the neg battery terminal for 30 min before pulling fuse no 31. Dont pull no 5 fuse underhood because you will disable both of them and there is more to do with the stering column etc. I can only speak for the passenger side


How do you disconnect day time running lights lancer?

On a 2008, fuse 13 (10 amp) located inside the fuse box in the engine bay controls your DRL. Removing it should disable your lights.


How do you stop your horn from blowingon 92 vigor?

Disconnect horns, disconnect battery, disconnect relay, disconnect fuse .........................................or repair problem.


How do you disconnect airbags in a 2002 Chevy Cavalier?

The airbags on a 2002 Chevy Cavalier are disconnected by removing the positive battery cable and pulling the airbag fuse. The wiring harness to the airbag can then be pulled to allow the airbags to be taken out.


How can the battery on a 2003 Honda Accord be kept fully charged when towing without pulling fuse 8?

Disconnect the battery. Alternatively you could run a wire from the ligter of the towing vehicle to the battery of the towed vehicle.


How do you disconnect the interior light?

you can pull the fuse


How do you disconnect car alarm for 1999 Chrysler 300m?

You can disconnect your 1999 Chrysler 300 car alarm by removing the car alarm fuse. The car alarm fuse can be found in the fuse box.