answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you fix a wheel bearing if put together wrong?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix the rear wheel bearings?

How do you fix a rear wheel bearing for a Lexus ls400


How to fix Mercury grand marquis 2001 wheel bearing?

Remove a wheel bearing on 2001grand marqus


Fix rear wheel bearing on vauxhall frontera?

replacing rear wheel bearings on frontera B


How much does it cost to fix a wheel bearing for Lexus rx 300?

1311.00


What will happen if front wheel bearing isn't replaced?

The bearing will eventually overheat and sieze or in severe cases could break the axle. Fix it ASAP.


How can I fix a problem regarding 1998 ford bantam wheel bearing?

Check your local library for a repair manual.


Where is the abs sensor located on a 2002 grand am?

The ABS sensor is located in the front wheel bearing. The is one on either side, so you will need a mechanic to pull the error code out of the car's computer to determine which side it is. You must replace the entire wheel bearing to fix the sensor, but chances are that if the sensor goes the wheel bearing is leaking. The wheel bearing is a sealed unit and should not leak, but over time, water, grime, and wear, it may begin to no longer be sealed. Buy a new wheel bearing and install it your self if you want. All you have to do is take off the wheel, the brake caliper, the rotor, and finally the bearing itself.


How do you fix the traction control system it keeps coming on when the gas is accelerated and when the brakes are pressed?

It's probably being caused by a defective wheel speed sensor. Sometimes this happens shortly before the wheel bearing fails, other times the sensor or the wire connection is faulty. Most times it is necessary to replace the wheel bearing assembly. The wheel speed sensor is integral to the bearing assembly.


How do you fix a squeaky noise coming from the driver side tire?

Perhaps brake pads need replacement or bad wheel bearing


How much would it cost to fix a wheel bearing on a 96 Toyota Corolla?

The cost to replace the wheel bearing on one side in the front of a 1996 Toyota Corolla will cost approximately $316 to $403 for labor. The cost for the parts are estimated to be $77 to $105.


Why is there a Clicking sound coming from the rear on my 2004 600 polaris sportsman?

Rear bearing is bad or cv joint is bad.check boots for rips.Check rear wheel bearing first that the cheapest fix


How do you fix a shacking problem after changing all the ball-joints on a 1996 escort lx 1.9L?

Did you do a wheel alignment? Check tie rods, wheel bearing play, and tire conddition.