You can, but it pays to get a licensed electrician to check your existing wiring as older cables have a poorer insulation that may have degraded further over time. This type of wiring has a real risk of overheating and causing a house fire.
Your house will probably be your biggest investment, better to be safe than sorry for the sake of a $75 call out; have somebody inspect for you.
It does if there is electrical charge going through the water and going into the algae and then the algae traps the electricity inside of it unless there is a break in the algae.
Electrical cords are insulated to prevent the electricity from going from one wire to the other wire without first going through the lightbulb or electrical device. Electricity is lazy. It would rather jump from the hot wire to the neutral wire and go back to the power plant without doing any work than have to go through the light bulb and do some work. You would still have to pay the electric bill.
A neuron is analogous to an electric wire. If you look at an electric wire going from a lamp to a wall plug, you do not see the actual wire. Instead, you see the insulation. If you would scrape off the insulation, you would see two wires. If those two wires touched you would hear a loud pop. Then a circuit breaker would throw. The wire would be just as good as it was before you removed the insulation. The wire carried the electricity. The insulation protected the wire and let it do its job. Without the insulation, the bulb would not work. The Myelin sheath protects the nerve from outside forces. It lets it carry its signal free from outside influence. It is a piece of insulation.
The voltage of the solar panel is less important than the total amperage. Proper wire size is determined by amperage that will be going through the wire. Wire INSULATION determines the voltage that a wire can carry.
The GFCI device compares electrical current on one leg of the breaker to the electrical current on the other leg and if there is any measurable difference, the GFCI shuts off immediately, before you can be harmed. The assumption is, if there is a difference, some of the electrical energy must be going through your body. Not a perfect solution, but not bad.
YES, If the insulation on the plug wires is degraded enough (old) ,water from splashing can act as a electrical conductor and ,if effect, short out the ignition on the affected cylinders.
It does if there is electrical charge going through the water and going into the algae and then the algae traps the electricity inside of it unless there is a break in the algae.
no it is manual
insulators or insulation does not permit electricity to flow through you.
Insulators are important because they stop electicity from going through the spot where the insulator is.
In the application of electrical wiring:the conductor (e.g. copper) carries the electricity where it is neededthe insulator (e.g. PVC) around the conductor keeps the electricity from going where it is not neededThere are many many other applications, this is just one.
The last I remember seeing cardboard lamp socket shell insulation was the late 50's or early 60"s. Going on the internet it looks like they can still be bought today for special applications. Once PVC became prevalent as an insulator in the electrical trade, the cardboard insulators were phased out.
It's when the electrical charge is not going through the heart correctly causing the valves to not open and close in sync.
the car with a spanner is an electrical fault warning light ( keeps flashing if there is a problem)
1st answer is that scaffholdings are going to have to be installed and taken off which is going to take some time
When you replace wall insulation, you are first going to have to tear down the entire walls. You will have to place a layer of foam and fiber to keep the wall warm.
Electrical cords are insulated to prevent the electricity from going from one wire to the other wire without first going through the lightbulb or electrical device. Electricity is lazy. It would rather jump from the hot wire to the neutral wire and go back to the power plant without doing any work than have to go through the light bulb and do some work. You would still have to pay the electric bill.