0
Yes, but I don't know how specifically. You need to know the wattage load that the car stereo can hold first to be sure the speakers can handle the power. Check the manual for the stereo specs and check the amp outage specs. After that, I'd ask an electronics store for any tips they have. Remember to be safe, you can get shocked if you rewire it wrong. Disconnect the battery first. Also, use wiring caps to connect the wires if there is no clear plug-in system. Good luck.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Pioneer super tuner 3 car stereo comes on but no sound?
I have no answer for you but mine does the same thing.
How do you hook up an vr3 200 watt 2 channel amp to a car stereo?
well you hook it up
How do you install subwoofers and amp in 2002 cadillac dts?
How do I install my output converter to my factory stereo in my car
How do you power a powered subwoofer to factory car stereo?
Take the rcas from the amp and connect it to the + and - posts on one of your speakers.
What is the box called underneath the passenger seat for a 1992 Lexus Es300?
That should be the factory amp for your car stereo
Where is car stereo amp on a 1994 Lincoln town car?
The car stereo amp on a 1994 Lincoln town car Is in the trunk, right side behind the seat
How do you hook up after market stereo in a 1996 Seville?
you have to bypass the amp that is in the trunk in the quarter panel and run wires from there to the front of the car where the new radio will stay not a fun car to work on
What type of stereo amplifier will match with the stock stereo unit on a 2000 Impala?
Look for a stereo amplifier with speaker-level inputs that can connect directly to the stock stereo unit in your 2000 Impala. Make sure the amplifier's power output matches the power requirements of your stock speakers to avoid any damage. Additionally, consider an amplifier with built-in crossover features to fine-tune the sound for your specific setup.
Why is your after market car stereo not as loud as the factory stereo in a Chevy Monte Carlo?
Could be the factory amp had more power than the aftermarket unit most are around 45-50 watts or so they clam. But I'm sure these are overrated as well.
How do you hook up a CD player to an amp?
well if its a factory CD player you can connect the rear speaker wires to the input on the amp you will have to take two ends off a rca cable and soldier the speaker wire to it the center being positive the p-con or remote wire on the amp can be connected to a wire that has 12volts when the key is turned on and well ground amp to chassis and get the power from the battery (this sounds kinda confusing but it worked in my car before I bought a aftermarket stereo)if a aftermarket CD player you can use rca cables from the rear or front output on the stereo to the input on the amp the remote for the amp can connect to the blue wire with white stripe on stereo
How do you hook up house stereo in car?
with ur hands
Can a capacitor hook directly to a car stereo without using an amp?
No. The capacitor is there to store the power so that the power isnt drained from the car at once. It helps reduce the strain placed on the vehicles electric system.
