0
What else can I help you with?
How do you hook subs up to your factory stereo?
Use a line out converter spliced into the rear speaker wires to connect RCAs to a sub amp.
Can you hook up subs to a stock rockford fosgate 2009 lancer stereo?
I need some help I gotta 2009 lancer and I wana pound hard need to know how too hook up subs and an amp up to my factory cd player its a indash six disk changer please let me know thanks
Can you hook up an amplifier to the stock 2006 dodge ram stereo?
yes you can i have an amp and subs in my 2006 dodge 2500 HD
How do you hook up subs and an amp to a stock stereo?
I have a 10" sub and an amp in my 2004 Chevy silverado. My dad got it for me but he also had to by a different stereo. I don't know if just the chevy stereo wouldn't work with it or if it's all stock stereos.
Is it possible to hook up two 12-inch subs to a Altima factory radio?
it is...but they wont perform properly nor sound right.
Can a Mazda 6 factory radio handle a 600 watt amp and sups?
The factory radio most likely doesn't have RCA jacks in the back, which is what you are going to want to use to hook the amplifier to the stereo to get the best quality sound. Otherwise you are going to have to wire the amplifier to the speaker wires using the high input plug that comes with the amp and you will get poor quality sound out and your subs will not have much bass (that is why it called the high input).
1997 Land Rover Range Rover is it possible to hook up subs and amp to the factory stereo or do i need to buy a after market CD player?
The answer is yes, you have to splice the wires going into the rear base speaker and amp, you will also need a special madule to connect the rca cable to the amp, make sure you get a good signal from the rear speakers...
What is Firehouse subs most famous sub?
hook and ladder
Whats the best way to have your subs facing in your trunk?
my experience in stereo work you get the deepest bass with the subs facing the open trunk area
How do you hook up a amp and subs to a 1999 Lincoln town car?
You first take the amp Then you take the subs. Then. Voila.
Can you hook up 2dvc subs to a channel amp?
Type in google 'subwoofer wiring' and click on the 'crutchfield' link. Really good diagrams on how to connect dvc subs and svc subs to any amp.
How do you wire an amplifier to 2 subs?
Mono amp: hook up 2 wires to the positive speaker output, and 2 wires to the negative speaker output. Hook the positives up to the positive leads on the subs, and the negatives to the negatives. Stereo amp: one positive wire to each positive output on the amp, same with negative. Make sure you get corresponding positive and negative to each sub. Stereo amp running bridged (mono): It's normally the outter positive and negative leads, but refer to the manual. Wire same way as a mono amp, just use the bridge outputs. Mono or Bridged would be running 2 ohms if you are running single coil subs. Stereo would be 4 ohms. If you have a dual coil sub (such as Kicker Comp VR), you would want to run stereo because those subs run 2 ohm's stock do to the dual voice coils. Or 1 amp per sub unless you have a 1 ohm stable amp, which most likely you don't.
