There is no electrical reason why this can not be done. Just remember that increasing wattage will add more draw to the circuit. If the circuit that the fixture is on has other loads, the circuit could be overloaded and may trip the breaker.
Yes, you can put a fluorescent light bulb in your floor lamp. You need to see what size bulb the lamp takes, but most sizes can be purchased as florescent bulbs.
In a floor lamp or table lamp a #16 wire is what you need.
No...
A subsystem for a lamp would be the bulb because the bulb lets the eye see.
A subsystem for a lamp would be the bulb because the bulb lets the eye see.
Yes, you can put a fluorescent light bulb in your floor lamp. You need to see what size bulb the lamp takes, but most sizes can be purchased as florescent bulbs.
Feng-shui principles say that a lamp can drain a person's energy if the light bulb is directly over the couch. If your floor lamp does not have a bendable top then the lamp can be placed anywhere in the couch's vicinity for good energy. If the lamp does have a bendable head make sure it is not bent straight down onto the couch.
In a floor lamp or table lamp a #16 wire is what you need.
Any HID head lamp bulb above 6000K are illegal.
changing head lamp bulb on Audi q7
changing head lamp bulb on audi q7
unplug the bulb from the lamp and pull the lamp off of the lamp adjustments (might take a pretty hard tug)
Get a flat head screwdriver and pop it off...then replace the bulb
An environmentally friendly modern floor lamp is much easier to purchase than it would have been a few years ago. However, it does prove to be more expensive than a "normal" floor lamp. A simple way of achieving a greener lamp is by using a energy saving light bulb. Alternatively a solar powered lamp can be purchased.
Bulb (Head light,or tailight,or stop light) not operating
Lamp have required high rating to glow & have a specific luminus area.exa-table lamp,florucent lamp,sodium vapur lamp,BUT but bulb have no required rating exa- halogin bulb
at the top of the head lamp unit you will find two black tabs. pull these tabs in the upward position, this will release the head lamp from the housing unit and allow you to change the bulb. Replace the bulb and insert mounting tabs back into holding area then push the two black tabs down to lock head lamp back into proper position.