Absolutely, the key is to make sure you are really using an unpowered mixer and that the signal level is correct for the power speakers (usually XLR will do fine).
Yes. In fact, I would recommend doing this instead of just running the mics through your band's powered mixer. That way, all your drum sounds (pre-mixed) will fit into just one input on your band's powered mixer. It takes about a minimum of 6 or 7 mics to capture a drum kit properly and that's a hell of a lot of inputs to be using on your band's P.A. Just run the mics through your own mixer, then run your mixer's "Main 1" output to your band's P.A. input. Use a balanced cable. Also, if the mixer that you are using is unpowered, then get yourself a couple powered monitors to run directly off of it so you can have some monitoring without using one of the the P.A. monitors. If your drum mixer IS powered, however, just get yourself some speakers and you've got yourself some monitors. In a nutshell, I recommend getting a small powered mixer for your drum mics (something with 100W minimum) with unpowered monitors running right off of it (use the "Main 2" output). Connect the mixer's "Main 1" output to your band's P.A. system for the final mix. But remember, if you do it like this, you have to dial in a good mix on your drum mics through your own little mixer because the sound guy will only be able to adjust the volume of the drum kit AS A WHOLE through the main P.A. system. This is what I do and it works very well.
A powered audio mixer is used for combining, mixing, routing and changing the level, timbre or dynamics of audio signals. They can mix analog or digital signals depending on the mixer.
a mixer
If this is the only speaker you are using, use the Main Mix outputs. The stereo tape outputs will not be controlled by the Main Mix fader/knob. If you are using main speakers plus an additional monitor, use an auxiliary send on the mixer to allow the creation of an independent monitor mix.
Mix music together.
cake to mix cakes. concrete to mix concrete audio to mix various audio signals mixer valve, to tune the radio and to produce a signal for IF amplification.
cake to mix cakes. concrete to mix concrete audio to mix various audio signals mixer valve, to tune the radio and to produce a signal for IF amplification.
A DJ mixer is used to mix audio sources together in to a single output. Typically the inputs are CD players, Ipods, Turntables and a microphone. The output of the mixer is low voltage and requires amplification by a separate power amplifer which in turn drives the external speakers. Because of the high volume levels and peaks (transients) regular domestic "HiFi" speakers aren't built strongly enough to last long. You will require either "Disco" or DJ speakers of PA (band) grade speakers.
Mixer's
A mix of salt and water.
To mix cake batter?
what attachment is used to mix dough