0
Yes, you can pan for gold in the Carson River, but it is not currently considered a likely area to find placer gold. The Comstock Lode area downstream from Carson City through Dayton was mined thoroughly in the late 1800's and there is little accessible gold remaining. Most of the river there is privately owned but some BLM land is near Dayton and the Fort Churchill Road. Only a couple of miles of poorly-accessible public land are along this Comstock reach of the main river. Substantial gold deposits have not been found in other areas of the river. Most of the river bed has recent sediments which are unproductive for minerals.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What was a gold pan used for?
Panning for gold. You go to the river get a bit of water, some dirt from the bottom of the river and then swish it around and over the lip of the pan. Eventually, you may have bits of gold in the bottom of the pan because the gold is heavier than the water and of the sand/gravel from the river. It is a wet job.
What do people use to look for gold?
Metal detectors, or they pan for it in a river.
What were at least 2 ways that found gold and collected gold?
you can either mine gold from the ground or pan it from a stream or river
Where is the best place to pan for gold in US?
Washington on the yakima river delta
Why you pan for gold in a river?
If u tried to dig for gold u would have to put it back in the river so the mud would wash off BUT the gold would go off TOO so u should use a pan, bottom line, ITS EASIER.
How much gold is in Colorado river?
1849... A lot of gold was in the river. Just stick a pan in, pull it out, and you could get half an ounce of gold. 2012... You`ll have to be lucky. There is not that much anymore. There was a gold rush here, too.
What do you trade for the gold pan?
You trade the oil can for the gold pan after you trade the saddle for the gold pan. Saddle to gold pan to oil can.
What was the pan used for in the gold rush?
The gold pan was used as a tool to separate the gold from the other river gravels. Gold is more dense than the gravel and will works its way down through the gravel under the right conditions. The gold pan helps provide these conditions. A miner would fill the pan with gravel and water. He or she would then agitate the material in the pan by shaking it side to side or in a circular motion. This would loosen up the gravel and allow the gold to sink to the bottom of the pan while the litter gravel was washed out of the pan by the moving water.
What if you trade the saddle for the gold pan instead of the oil?
You go to the river and search for the gold nugget. You then buy the tonix (or whatever) and then you go back to the trading outpost and trade the gold pan for the oil can. You then use the oil can on the clock tower and then your good to go!
Why was placer mining the most widely used method or mining for gold?
It was an easy method to find gold. All a man needed was a gold pan, and find a spot on the river to pan. Some got a bit more fancy with a sluice box or rocker to seek gold.
Why was placer mining the most widely used method for mining for gold?
It was an easy method to find gold. All a man needed was a gold pan, and find a spot on the river to pan. Some got a bit more fancy with a sluice box or rocker to seek gold.
How was panning used?
people went by the river and dip the pan in the water and shake it ,until they find gold rocks.
