A previous member answered:
"No. You will need a step up transformer to be able to use 110v appliances in 100v sockets."
This is incorrect. In the US, the AC supplied to household outlets may be called 100, 110, 0r 120 Volts. These all refer to the U.S. nominal 110 Volt supply, which can range from as low as 95 volts and as high as 125 volts and most appliances labeled for 110 Volts may be used in the socket. Generally, if the plug fits, it's safe.
A 220v motor uses two 120v legs. But for your question, no, because it needs another
120v wire to run.
No you cannot plug a 100v into a 120v outlet, it will fry whatever the product you are plugging up.
Yes you can plug a 100 V motor into a 110 V outlet. The 10% increase will be well within the tolerance levels of the motor.
Yes
No. Attempting to run an appliance on insufficient voltage can cause damage to the appliance and can be dangerous. Call an electrician and get him to install a 220v plug
Yes you can safely do this. Most appliances that are marked 115 volts will operate on outlet between 110 and 120 volts safely.
Do not do this.
If it's rated at 110 then you can safely plug it in to a residential outlet. But, because it is generating heat, it will be drawing substantial voltage so you should ensure that the appliance is on its own circuit; otherwise when someone else turns on a light, or plugs in another appliance, the circuit will overload and shut down.
Probably not, but I have yet to see a 150 volt appliance as this is a non-standard voltage. If you are referring to a 115 volt appliance then the answer is yes you can as 110/115/120 volts tend to be used interchangeably in practice and are close enough together to not affect operation of the appliance.
You will burn up your appliance!!!!!
Only if it is rated for 110V-220V. If it is rated for 110V only and you plug it into a 220V outlet, your device will be destroyed.
Assuming the wiring to the outlet has 2 loads and one neutral, isolate one load from the outlet and use the neutral as the common. be sure to ground from the receptacle to your conduit or ground lead. You should also replace the corresponding breaker with a 120 volt single breaker.
Yes, it uses an AC power adapter.
No, the pin configuration would not allow this to happen.
Yes.