0
What else can I help you with?
Could a Toyota tercel pull a truck on a trailer?
A Toyota Tercel is not designed to pull a truck on a trailer. This vehicle has a very low tow capacity at about 800 to 1200 pounds depending on the model.
How do you change a flywheel on a 1991 Toyota Tercel?
Pull the motor out of the car and change it.
How much trailer weight can my 2008 Toyota Prius pull without causing it issues?
You need to read the owners manual! The Toyota manual states the Prius is not designed to pull a trailer.
Is it possible to pull the engine on a 1993 Toyota Tercel without pulling the manual transmission?
maybe
The check engine light does not go off on your 94 Toyota Tercel until you turn off engine?
Check engine lights will not turn off in a vehicle until they are reset. To reset the light on a 1994 Toyota Tercel pull the ECU fuse.
How do you replace 1991 Toyota tercel right tail light?
open the trunk, and pull back the carpet and there will be 2 nuts holding the light in place. unscrew them and pull the light out.
How do you open the hood of a 1987 Toyota tercel when the hood release doesn't work?
Find were the cable connects behind your grill and pull that lever Find were the cable connects behind your grill and pull that lever
Why can't you pull a trailer?
I can't pull a trailer because I do not have a trailer hitch on the back of my car.
Will it pull 5500 trailer?
Sure! Oh wait, will what pull a trailer?
How do you remove front speaker covers from a 1998 toyota tercel?
There is a little wedge at the bottom, stick a nail fail there and pop it out. Then you just have to pull the cover down to reveal the speakers
How do you disassemble the rear brakes on a 1993 Toyota Tercel?
pull the center cap off, pull out the cotter pin, unscrew the bolt. work the drum off ( may take some prying ) and then all the drum internals will be exposed.
How do you change the release bearing on a 1985 Toyota tercel?
You need to pull the halfshafts, to get to the trans axle. Then pull the transaxle out from under the car and the release bearing is on the transaxle shaft, you'll need to get a bearing puller to get the bearing loose from it's housing.
