0
What else can I help you with?
Can you put a Nerf bandolier on a Nerf longstrike?
Yes.
How many darts does the Nerf stampede use?
Well it comes with three 18 clips and a 6 clip it comes with 60 darts and i depends witch clip/drum you put in.
Does the Nerf vulcan run without batteries?
yes if you put on the thing thats on the longstrike
On the Nerf longstrike can the stock come off after you put it on?
Not in less you open it up and take out the locks
Is there Nerf shields?
yes there is you can get a Nerf shield to put on your gun it is called the stampede shield, or you can get a shield that comes with a n force sword
How do you stop your Nerf stampede from jamming?
You shouldn't need to worry about the Stampede jamming, as since the beginning of September when I had it, it's only done so a couple times. If it does, you should remove the clip, center the darts inside the clip, and put it in again. You should also remove, if there is one, the dart in the chamber. Jamming can be avoided if you take your time in loading darts into the clip, as usually when jamming it's the darts in the clip that have been put in the wrong way, not centered enough, or are just too warped to be shot correctly.
How do you mod a Nerf drum to make it a clip?
by breaking it and put parts in it
How do you put the Nerf bullets back into the clip?
well if your talking about the clip,you just put the dart in ,but when you put the second one push the first down then put the second one in then just keep doing that and thats how you put darts back in into the nerf recon cs6 by:jrock 54.
How do you make a Nerf longshot shoot anything?
put the Nerf darts in the ammo clip facing the right way pull back the orange thing that is on both sides until it clicks put the ammo clip in push the orange thing forward until it clicks pull the trigger
How do to assemble Nerf longshot?
put the two guns together, slide on the scope, put the darts in the 2 clips and put one clip in the stock on the back, and load one in the gun.
How do you put the Nerf recon cs6 on the bandoiler belt?
You can, but I have tried it and only the pistol mode with no acessoreis (even the clip) will fit in if you stretch one of the clip holding things really hard and slide it in. I have tried to put in the nite finder and the maverick, but they barely fit into the clip holders just like the recon.
How do you put a laser on a Nerf gun?
There are two ways to do this: 1. buy a laser pen and do some drastic surgery on a Nerf gun involving tape, glue and sweat or 2. get a tactical light and clip it onto the tactical rail.
