u probally could but you might need to mould it
Threaded bars also any size. But not oversized bars only regular
Any 1 1/4 inch bars, basically the average size and if you was to use Hic any 1 3/4 bars would also fit. But you would need an oversized clamp to run Hic.
The clamp is an oversized triple clamp which comes in a variety of colours the clamp is really good on gripping the bars to the forks. The forks are slamm own make aluminium threaded scooter forks. The bearings are crap would like to tell you to replace them with grit or MGP bearings as they are good at gliding the bars on a spin. The clamp is a very good clamp must say would not replace as really good.
yes they do fit but you also have to make sure you have the right clamp.
Yes... If you have Grit Invader bars, they will fit and look the best.
no they do not because i bought some over sized bars and they didn't fit my grit elite 2
yes
yes you can
Yes they do, but you may have to buy a new clamp.
No i dont think so. I have a razor double clamp an i tried to fit it on my grit alloy bars i had to force it and it still dont force in. I had to buy a brand new clamp
They do if u measure the width of the bars it comes to 510mm so it would fit comfortably on the scooter
A grit scooter is better (I would recommend the extremist or the elite 2)