answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you put the split duplex receptacle on the same circuit as the other duplex receptacle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a split receptacle?

Between the two screws of the outlet there ais a break away tab. If that tab is remover the outlet will become split.


What is the main advantage of a split-feed receptacle?

The main and only advantage of using a split receptacle is the ability to use two 1200 watt appliances on the same duplex outlet. If the receptacle was not split the total wattage would be 2400 watts. Amps = Watts/Volts. 2400/120 = 20 amps. This load would trip a 15 amp circuit breaker.


Do I need two ground wires -one for each socket- if I split an outlet?

No. You can split the hot feeds and you can split the neutral feed, but both outlets of a standard duplex receptacle share the ground.


What are the advantages of a duplex?

The main reason people opt in owning a duplex is the affordable homeownership. Most go into a lease with other friends and split the cost of the morgage.


Why would only one plug-in work in a two plug-in outlet?

Two reasons. In older wiring or possibly new depending on the region, it was common place to split a receptacle especially in kitchens so that the top half was on one circuit and one was on the other. You may have a tripped breaker. Otherwise, the receptacle was cut to be a split receptacle and never wired that way. If you feel safe doing so, pull the receptacle out of the wall with the POWER OFF. Look at the sides where the wires are screwed down and see if the metal tab that runs between the two screw per side is still intact. If its not and you want the receptacle on a single circuit, replace the receptacle, but this time, don't cut the tab.


Why do two circuit breakers control the same circuit 120 volts on all devices in circuit?

Circuit breakers are like fuses that you can reset. There is no need for two though because they do the same job as one, which is to open the circuit as soon as the voltage that is being called for by all the devices becomes greater than the 120v you mentioned. <<>> It sounds to me like you are talking about a three wire split receptacle On kitchen counter plugs and sometimes other locations the electrical code requires that split receptacles be installed. This request came about by people trying to plug too many appliances into one 15 amp circuit. The circuit not being able to carry the load and constantly tripping the breaker. On a split receptacle the tie bar is removed on the hot side (brass) of the receptacle but not on the neutral (silver) side. The red wire is connected to the top brass screw, the black wire is connected to the bottom brass screw and the white (neutral) wire is connected to the other side of the receptacle The rating of the breaker in the panel will be, 2 pole 15 amp. What this gives you is 2 separate 120 volt 15 amp circuits on one receptacle If the voltage was measured between the two hot slots on the right side of the receptacle top and bottom you would measure 240 volts. This voltage would only be 240 if the breaker feeding the receptacle was full size 2 pole and not mini breakers.


How do you run a split circuit 15amps?

Answer forUSA, Canada and countries running a 60 Hertz supply service.Split receptaclesSplit receptacle installations can be found in kitchen counter receptacles. These types of receptacles are fed with a #14 three wire from a two pole 15 amp breaker. The top part of the duplex receptacle is isolated from the bottom half of the duplex receptacle by removing the brass coloured tie bar that joins the two halves together. The top part of the receptacle is fed with a full 15 amp capacity by using the black and white wires of the three wire cable and the bottom half is fed with a full 15 amp capacity by using the red and the same white wire of the three wire cable. This allows two appliances to be plugged in to the same receptacle.SAFETY ADVICEBefore you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energizedIF YOU ARE NOT REALLY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.


What is a Quadplex?

A Quadplex is like a Duplex. If a Duplex is a house that is split in two to accommodate 2 families, then a Quadplex will be split in four 4. For more on duplexes, go here: http://en.wikipedia.org/wiki/Duplex_(building)


Can a 2-pole circuit breaker be used for 110V 220V or 440V?

All three, on 110V a split receptacle, on 220V a baseboard heater, on 440V a construction heater or similar resistive load.


Why is voltage split over a series circuit?

Voltage drop due to the resistance present in the series circuit causes voltage split over a series circuit.


What is split time in car racing?

Split time is recorded at a certain part of the circuit, A race circuit is usually divided into four sections the split time is how fast you are on the sections.


What is a parallel circiut?

Something that contains a voltage circuit and wires.