answersLogoWhite

0

It's not exactly good for it....especially for a computer controlled car. It requires the proper coolant temp to adjust the fuel system, timing, etc. But yes, you could drive it.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What happens when a thermostat is stuck closed?

The engine will overheat violently, serious damage can occur if you continue to run the engine.


What happens if you remove thermostat in car engine?

It will always run cold so it will run inefficiently.


How do you change thermostats in a cat C-15 engine?

To change the thermostat in a Cat C-15 engine, start by draining the coolant from the system. Locate the thermostat housing, remove the bolts securing it, take out the old thermostat, and clean the housing. Install the new thermostat, ensure proper orientation, reattach the housing, and refill the coolant. Run the engine to check for leaks and proper thermostat operation.


Can your 2001 Maxima run with out the thermostat?

NO,never good to run any car without a thermostat will ruin your engine


How do you change an engine Thermostat on Renault Laguna 2.2 Turbo diesel?

To change the engine thermostat on a Renault Laguna 2.2 Turbo diesel, first, ensure the engine is cool and disconnect the battery. Drain the coolant and remove any components obstructing access to the thermostat, such as the intake manifold or hoses. Unbolt the thermostat housing, remove the old thermostat, and replace it with a new one, ensuring the gasket is properly seated. Reassemble everything, refill the coolant, and run the engine to check for leaks and proper operation.


How do you replace the thermostat on a 99 model Pontiac grand am?

On the 2000 models with the 3400 engine in it you must first remove the throttle body. Removing the throttle body makes access to the thermostat housing very easy. Simply take 2 bolts out of the housing and remove the thermostat. After replacing thermostat you must bleed the air out of the system because it is pressurized. Not bleeding out the air can cause severe engine damage if allowed to run. overheatin of the engine is the first sign.


Why does sable engine run cold?

Stuck open thermostat.


Where is the thermostat on a 2002 elantra Hyundai?

on the drivers side of the engine. you need to remove air box then the hose that connects to thermostat. Still stumped? run your car until its at running temp. Then carefully touch radiator hoses. follow the colder hose to the engine and your there.


What cause blower motor to continue to run when car is turn off?

The fan motor is controlled by a thermostat. When you turn off your car if the water temperature is higher then the thermostat is set for. the fan will continue to run until the temperature comes down then shut off. If the thermostat is faulty the fan will either run continually or not at all.


Where is the thermostat sensor located on the motor of a 2001 Malibu?

Drain the coolant down. Remove the upper radiator hose at the engine end. Remove the bolts holding the thermostat housing. Remove the housing and the thermostat. Clean the housing and the intake manifold and install the new thermostat and gasket. Reinstall the hose and refill the radiator. Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level


How do you change the thermostat on a 2003 Dodge Durango?

The thermostat for a 2003 4.7 is at the end of the bottom hose not the top. The 2003 4.7 is the only one at the bottom. You have to undo the bottom hose from the engine and the gasket is the rubber around the thermostat and the spring goes on the engine side. 1. Drain cooling system and dispose of coolant properly. 2. Remove lower hose from entry at thermostat housing connected at engine block and remove thermostat housing. 3. Remove old thermostat and replace with new thermostat spring side on engine side, there is also a tab that aligns with thermostat housing to prevent improper installation. 4. Replace thermostat housing. 5. Replace lower radiator hose. 6. Fill cooling system with manufacture directed coolant and check for leaks. 7. Run engine until thermostat opens and bleed air from cooling system.


How do you deprressurize the fuel system?

With some vehicles you can remove the fuel pump fuse as the engine is running, it will continue to run until the pressure is gone.