You can and it will work as long as the circuits load remains below 10 amps. Any load amperage over 10 amps will continue to blow the smaller size fuse.
I believe that it's either a 10 amp fuse or 20 amp. Check your fuses out. It should tell you.
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
No, you cannot replace a 10-amp fuse with a 20-amp fuse. Fuses are meant to guard your wiring and equipment by melting or 'blowing' before the wiring, itself, melts and causes a fire. It is safe to use a smaller fuse than called for, but never, ever is it safe to use a larger fuse than called for.
no you cannot, it is dangerous, you need to have a 20 amp service installed in order to do that. hope i helped
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
no
No, you could overload the wiring and start a fire.
10 amp... in socket # 20
The purpose of a fuse it to protect the wire that goes to the load. A 15 amp fuse protects a #14 gauge wire. A 20 amp fuse protects a #12 gauge wire. To answer your question if the wire size is #12 coming from the 15 amp fuse now then it can be upped to 20 amp fuse. If it isn't then you are taking the risk of overloading the #14 wire with a 20 amp fuse. This can lead to insulation failure of the #14 wire, overheating with the possible outcome of a fire breaking out somewhere in the circuit.
If it is the right size, then yes. But why would you want to do that? if the slot is meant for a 20 amp fuse then most likely there will be more than 10 amps running through it and it will blow almost imediately
Sure.If you want a fire, that is!AnswerNo. A 30A will cook the wire before it pops.