0
Can you restrict the flow on a submersible without harming the motor?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type of motor used under the water?
It is submersible motor.
What is the required thickness for 3 phase 3 HP AC motor?
The thickness of a motor is governed by the manufacturer that makes the motor. Some motors are built long and slender for example a submersible pump for a water well. Others are built with not much depth front to back but will have a diameter of six feet for example a synchronous motor for a large air compressor.
What motor must be never run without a load connected to them?
DC Series motor should never run without load connected to it because starting torque for DC series motor is infinite and running it on no load will damage the motor due to overspeeding.
Can you wire a 3 phase 690 volt delta star motor to 480 volt 3 phase with out harming the motor?
Depends on the motor and the load on that motor. If the motor is loaded to its capacity, it will draw the same amount of power as it would on 690 volts - which will result in ( 690/480 = ) 144% of normal current, which will thermally damage the motor, or will trip overload protection.
How can you find motor FLA without the motor nameplate The motor is single phase 120 vac?
use clamp on amp meter
What type of motor used under the water?
It is submersible motor.
Why is your submersible pump not working?
No power to pump. Motor burned out. Intake is clogged. Impeller disconnected from motor.
How do you keep raccoons away without harming other animals?
I can take raccons with out harming them by being kind and not harming and that's ima do cause raccons live on top of my house i am not klidding
Can a 240 volt single phase motor be supplied with one phase until the other phase is closed without harming the motor?
Not a good idea. Use a double pole single throw switch to start and stop the motor if motor HP is small. Use a motor contactor on larger HP motors.
What are the connections for a submersible motor with capacitor start?
The colors are red to red, black to black and yellow to yellow.
What types of sump pumps are available to a general consumer?
Currently, there are only two major types of sump pumps available to the consumer en masse. These are pedestal and submersible. A pedestal pump has its motor attached to the top of a shaft while a submersible sits below water level in a basement.
Will a 2 hp Franklin submersible well pump motor fit a 1.5 pump?
There is no such thing as a 1.5 pump. - Pumps are rated in gpm and inches. If the pump end is 4" , it will fit any 4 " Franklin motor.
What is the required thickness for 3 phase 3 HP AC motor?
The thickness of a motor is governed by the manufacturer that makes the motor. Some motors are built long and slender for example a submersible pump for a water well. Others are built with not much depth front to back but will have a diameter of six feet for example a synchronous motor for a large air compressor.
Can i not use a capacitor on a motor equipted with the motor?
No. You won't be able to start the motor without the capacitor.
Wiring diagram for three phase submersible pump 5.5 hp?
pump motor+overload+magnetic contactor+breaker
Can the motor run without winding?
no.
What happend when you start motor without starter?
The windings of the motor will be gonebecause of high current diectly goes to the windings of motor.
