It is submersible motor.
The thickness of a motor is governed by the manufacturer that makes the motor. Some motors are built long and slender for example a submersible pump for a water well. Others are built with not much depth front to back but will have a diameter of six feet for example a synchronous motor for a large air compressor.
Submersible sump pumps typically use mineral oil as insulating oil, which helps to cool and lubricate the motor while preventing electrical shorts. In some cases, biodegradable or synthetic oils may be used for environmental considerations. These oils are designed to have good thermal stability and low volatility to ensure optimal performance in submerged conditions.
DC Series motor should never run without load connected to it because starting torque for DC series motor is infinite and running it on no load will damage the motor due to overspeeding.
Depends on the motor and the load on that motor. If the motor is loaded to its capacity, it will draw the same amount of power as it would on 690 volts - which will result in ( 690/480 = ) 144% of normal current, which will thermally damage the motor, or will trip overload protection.
It is submersible motor.
No power to pump. Motor burned out. Intake is clogged. Impeller disconnected from motor.
I can take raccons with out harming them by being kind and not harming and that's ima do cause raccons live on top of my house i am not klidding
The colors are red to red, black to black and yellow to yellow.
Currently, there are only two major types of sump pumps available to the consumer en masse. These are pedestal and submersible. A pedestal pump has its motor attached to the top of a shaft while a submersible sits below water level in a basement.
There is no such thing as a 1.5 pump. - Pumps are rated in gpm and inches. If the pump end is 4" , it will fit any 4 " Franklin motor.
It is not recommended to supply a 240 volt single phase motor with only one phase until the other phase is closed. This can cause imbalanced current flow, leading to motor overheating and potential damage. It is best to provide both phases simultaneously to ensure proper operation of the motor.
The thickness of a motor is governed by the manufacturer that makes the motor. Some motors are built long and slender for example a submersible pump for a water well. Others are built with not much depth front to back but will have a diameter of six feet for example a synchronous motor for a large air compressor.
A 5hp submersible well pump typically has a motor power of 5 horsepower, designed to be submerged in water for pumping. It is capable of pumping water from deep wells, with a high flow rate and pressure capacity. These pumps are durable, corrosion-resistant, and suitable for residential or agricultural use.
No. You won't be able to start the motor without the capacitor.
pump motor+overload+magnetic contactor+breaker
no.