Residential power is usually 115 volts to 120 volts and will power a 15 amp air conditioner. If it is on a 15 amp breaker it may heat up the breaker and cause it to trip if it runs continuously in which case you would need to move it to a 20 amp circuit.
A 20 amp circuit will handle 18 amps continuously without overheating the breaker and making it trip. A 15 amp circuit can handle 12 amps continuously without over heating the breaker.
You cannot simply replace the 15 amp breaker with a 20 amp breaker because the 15 amp circuit uses smaller wire which might overheat.
The term 110 is an old one. Most home power now is at least 115 volts.
Watts x 3415.179 = BTU/h.
1725
No adapter is needed, 110 and 115 volt are interchangeable.
No a 230 volt appliance should not be pluuged into a 110 volt socket (And vice versa) you need to buy a converter that can be plugged into the 110 volt outlet then the appliance can be plugged into the converter.
Yes, a 110 volt device can be plugged into a 125 volt receptacle. The voltage rating on the receptacle is only there as the highest voltage supply that the manufacturer recommends their equipment be connected to.
No, the plugs are different to prevent this and even if you could the lamp would be very dim.
it is likely that a floating neutral is the cause of this problem
no
Yes.
No adapter is needed, 110 and 115 volt are interchangeable.
zzzzzzzzzzzAAAAAAAAAAAAAAAPPPPPPPPPP !!!!!
No, the applied 110 volt is too high for a 3 volt appliance. The appliance would burn out right away.
Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.
Nominally 110 to 120 volt power strip is okay to connect to a standard outlet.
No conversion needed. These are nominal voltages which range from 110 to 120 volts. It will operate fine on the outlet.
If you are about to purchase a window unit, the answer depends on a few factors: 110/115/120 volt units are generally not available in the larger cooling capacity sizes. If you need to cool one average sized bedroom and have a 110 outlet near a window, this should do the trick, and you won't need an electrician to install new wires. If you need to cool an entire house, then you are going to need a 220/240 volt unit or multiple 110 volt units. If you are talking about a central system, then the furnas, or indoor section will most likely be 110 volt and the outdoor unit 220 and you will need to have it professionally installed anyway.
Because a toaster does not pull near the current that a cloths dryer does.
Because a toaster does not pull near the current that a cloths dryer does.
No a 230 volt appliance should not be pluuged into a 110 volt socket (And vice versa) you need to buy a converter that can be plugged into the 110 volt outlet then the appliance can be plugged into the converter.