answersLogoWhite

0

You could, but it is not a good idea.

The check engine light may turn on, and a cold running engine is prone to oil sludge issues.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What controls the cooling fan on a 1989 dodge spirit?

The temperature sending unit reads the temp of the coolant then sends a signal to the computer thought the relays on the diver side inner fender (in front of the strut tower). Then to the plug to the fan. The 4 cly and the 6 cly uses the same sensor. It a two wire sensor the sets right next to the thermostat housing.


What is the firing order for 1994 dodge ram van 6 cly?

1-6-5-4-3-2


What is the spark plug gapping specifications of a 1997 dodge Dakota?

.040 on V-6 & V-8 .035 on the 4 cly


Does a 1991 dodge shadow have an electronic speedometer?

Yes. The sensor on a 4 cly is on the back of the transmission on the passenger side near where the right drive shaft comes out. On a V6 it is on the other side.


What fuses do 1966 dodge use?

They were small round cly type. Had metal ends with a glass tube in the center. Amp was written on the end. Can still be found at the auto parts stores.


Who is Medusa's Parents?

cly


How did Jerry Cruncher know that Roger Cly was still alive?

Jerry had dug up cly's coffin and knew that it was empty


How do you replace alternator 1998 dodge caravan 3liter 6 cly?

Remove the belt first, then there are two 15mm bolts that hold it in place. Remove those and it should just wiggle right out.


How do you put a thermostat on 1989 Jeep Comanche pioneer It is a 6 Cly ce?

To install a thermostat on a 1989 Jeep Comanche with a 6-cylinder engine, first, ensure the engine is cool and disconnect the negative battery cable. Remove the radiator hose connected to the thermostat housing and unbolt the housing to access the thermostat. Replace the old thermostat with the new one, ensuring it is oriented correctly with the spring side facing the engine. Reassemble by reattaching the housing and radiator hose, then reconnect the battery and check for leaks.


How did Jerry Cruncher know that Roger Cly was still alive in A Tale of Two Cities?

Jerry Cruncher knew that Roger Cly was still alive because he overheard Cly's associates planning to fake his death to escape punishment. Later, he discovered Cly's body in the coffin being used to transport him out of the country, confirming his suspicion.


What did John Barsad tell Carton about Roger Cly?

John Barsad told Carton that Roger Cly had been murdered and buried under the alias of Barsad's brother Solomon Pross. Cly had agreed to fake his death in order to frame Darnay for treason and secure his own safety and wealth.


where is cly 1 2 3?

The phrase "cly 1 2 3" is not clear. Where would it be used - please explain and resubmit your question.