answersLogoWhite

0

No, the motor has to be connected to the line voltage through a set of fuses and then an electrical contactor. Also the motor must be thermally protected against overloads by using an overload block or heaters. This is to allow the motor contactor to drop out is a overload fault should occur.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What current will be consumed by a 20KW motor?

To answer this question the voltage of the motor needs to be stated.


What size wire do you need going from a 20KW 83A generator to the main 200A automatic transfer switch?

In conduit? direct burial? distance?


What is a good model for a stand by generator?

The Generac Guardian Series 5875-20kW Smart Circuit Standby is a good standby generator which will power your whole home in the event of a power outage.


What is the KWh for 500 kw induction motor on idle running?

on idle, probably 0. KWh = KW x time (hours) . eg. 20KW for 5 hours = 100KWh (edit. ignore this answer i do not know what exactingly a idle motor is)


Is 20kw higher than 10kw?

yes


How many all electric homes can be powered by a 20KW generator?

It would depend on the energy consumption of each home. Generally, a 20kW generator can provide enough power for 1-2 all-electric homes, assuming average energy usage. It's important to consider the specific energy needs of the homes to accurately determine how many can be powered.


How much bhp does an exhaust add to a r33 skyline gtst?

say around 15-20kw with a striaght throw exhaust from turbo with no cats


How many amps will a 240 volt single phase 20KW generator supply?

Typically 75 amps on natural gas, 85 amps using propane. Peak amps(for less than a second) to start a big appliance, like an A/C condenser, are 130.


What size of wire you need to feed commercial kitchen equipment three 3kwovens a 20kw water heater and 3kw deep fryer?

You should contact a certified, and licensed electrician.


What size of wire and breaker do you need for a 20kw electric furnace?

In order to properly size the wire per National Electric Code (NEC) standards you will need to know the amperage and the distance of the device (heater) from the source (circuit breaker panel). In order to know the amperage one would need to know the voltage since amperage changes inversely with voltage.


My 1989 1600 Ford Laser engine was redone but still sluggish on the road and i dont know why?

y dont you try modifying the head take it to the engineers and do a port and gas flow it cost me r2500 and ive gained 20kw give it a try


How much gas will a 20kW generator use if run 24 hrs a day?

The amount of gas used will depend on the fuel efficiency of the generator, which is typically measured in gallons or liters per hour. Without this information, it is not possible to provide an accurate estimate. It is recommended to check the generator's specifications or consult the manufacturer for this data.