There isn't enough room under the hood.
There isn't enough room under the hood.
There isn't enough room under the hood.
They go through the transmission bell housing from the driver side.
6
It is the part of the transmission case that bolts to the engine.It is the part of the transmission case that bolts to the engine.
70 ft lbs
It bolts through the top rear of the transmission bell housing.It bolts through the top rear of the transmission bell housing.
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ
The bell housing is the part of the transmission case that bolts to the engine.
The bell housing is the part of the transmission case that bolts to the engine. It houses the torque converter.
Unless there is an actual drain plug on the pan then you have to remove the bolts holding the pan. R.W.
The bell housing is the front part of the transmission case. It is what houses the torque converter and bolts to the engine.
Remove the bolts holding the console down and remove.