yes
Yes
The center brake light bulbs can be replaced by lifting up on the rear light assembly and pulling towards the front of the car. www.lextechautomotivellc.com
First you buy a good-quality 3rd brake light kit appropriate for the mounting angle on your particular car -- see the links below for examples. If your car's left and right brake lights are separate from the left and right rear turn signals (different bulbs for the brake lights and turn signals), then you just follow the instructions with the kit. If your car has combination brake/turn lights (the same red light burns steadily for brake light or flashes for turn signal) then you must run a new wire from the brake light switch to the rear of the car to feed the new 3rd brake light -- cars with combination brake/turn lights route power from the brake light switch through the turn signal switch and then from there to the back of the car; if you try to get away without running the new wire, the 3rd brake light won't work properly and you'll backfeed other lighting circuits with random results.
The brake light is telling you there is a problem with the brakes. There could be several reasons. Have a qualified mechanic check the vehicle's brake system soon!
To reset the brake light on a BMW 645Ci, first, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal three times in quick succession, then turn the ignition off. Start the car again, and the brake light should be reset. If the light remains on, check the brake fluid level and the brake light bulbs for any issues.
AnswerIf this were my car, I would replace the brake light switch ( near the brake pedal ). This could be the problem and is about the cheapest thing to start with. Good luck.check the ground connection at the taillights a bad ground will cause this
its a rear bulb failure indicator if it comes on when brake is first depressed it is a brake light bulb if it is on when you start the car it is a ride light or park light
The brake light bald can be accessed through the trunk of the car. Remove the rear tail light cover to access the brake light bulb.
When you feel the need to slow down or stop... Brake lights are universally required to be used on all public roadways throughout the modern world. Many countries have adapted the 'Third' or center brake light for added visibility.
The light on the dash that says the emergency brake light is on could have burned out if it does not light up when the emergency brake is actually on. In some vehicles, this light will not light up until the car is put into gear to warn the driver that the emergency brake is still on.
Brake Light switch works without the ignition on. unplug the brake pedal switch and check to see if the brake lights are still on..switch could be defective
If you step on the brake pedal , yes