Yes. If you have a device rated at 12 Volts and 150 milliamps, you can use any power supply that will deliver at least 150 milliamps at 12 Volts. The important item is to keep the 12 volts at 12 volts. Even if you had a power supply that delivered 2000 amps at 12 volts you would be OK as it will only draw the 150ma that it needs.
i am not sure, BUT according to the answer in this post:Can_you_use_a_9V_600mA_adapter_on_a_9V_400ma_scanneryou need an adaptor of 9v and AT LEAST 500mA (assuming that the appliance draws 500mA)
Using a 12v 600ma source is allowing 12 volts and 600 amps of power. If the device requires a 12v 500ma source, the larger source is acceptable. Please note that it will only be drawing on 500ma of the available 600ma.
12v 1000mA means that the maximum output of that unit is 1000 milliamps at 12 volts. 12v 150 mA means that the maximum output of that unit is 150 milliamps at 12 volts. So if you need 150 milliamps at 12v either will do. BUT if you need over 150 milliamps at 12v then you must go for the 1000 mA unit. By the way there are 1000 milliamps in 1 amp.
If the camera actually uses 700 mA in order to do its job, then the 500 mA adaptor will warm up, then overheat, and eventually fail.
The adapter's voltage must match that of the device, and its current-rating must exceed that of the device. So the answer is yes.
A 12v AC adapter can be use to power devices that requires 12VDC and up to 500mA. It can also be use with electrical devices that require power but do not contain internal components to derive the required voltage and power from the main power.
For power supplies, if the voltage is the same, the rated amperage is equal to or greater than the requirements of the device, and the plug fits, the supply is safe to use.
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device
500mA = 500 miliamper 1000mA = 1 amp so 500mA = .5 amps
No, you can leave it on for about 12 ours or overnight. You could also buy a Battery Tender for about 30 to $40 and not have to worry about leaving it on for tool long. (I use one, and I have no interest or affiliation with Battery Tender.)
Power = volts x amps, so your example will be 12 x 0.5 = 6 watts. (500mA = 0.5 amp) Note we don't talk of 'watts per hour', it is just watts. 1 watt = 1 joule per second
Not for very long. If the device actually requires 2A in order to do its job, then the adapter ... which is only designed to deliver 0.5A or less ... will get warm, then overheat, and then fail. Possibly in as little as a few seconds.