No, it has to do with the insulation rating of the individual cords. 12 volts can be used on a voltage rating of 120 volts. But 120 volts can not be used on a 12 volt rated cord. As a point of interest most power cords have an insulation rating of 300 volts.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
yes
No this will not work you will draw approx. 2.291 amps@275w that is approx.2291 mA
Yes. In the United States, standard household voltage is 120VAC @ 60Hz. If properly installed, you can also run standard devices at 220 or 240 volts AC in the US.
The power supply for the Sunpentown WA-1340DH Portable Air Conditioner/Heater Combo is 115V / 60Hz.
Input would be 120v at 60hz. Standard US wall power.
It is 120V/60Hz
You need amps
Household is 120/240 volts at 60Hz. The average wall socket is 120v 60Hz.
Check the wattage of the device that plugs into the adapter. If the device's wattage is lower that 25 watts then the answer is yes. If the device's wattage is higher that 25 watts then the answer is no.
No, 120 v is not enough.
You can get a transformer that converts the UK's 230V power to 120V, but you cannot get a transformer that will convert from 50Hz to 60Hz. Often, US equipment can work, except that they will work hotter and less efficiently on the 50Hz power. Consult your clipper and trimmer documentation - you may find that it will work just fine on 50Hz.
Same as the American standard, 110/120V at 60Hz. A Google search for "International Mains Voltages" will provide lists of the voltages and frequencies in many countries.
no because the tv can only pick up siginals at 60Hz if the signal is 50 Hz it won't pic it up.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
In North America, Japan and some of northern South America, standard power supply is within 10% of 120V at 60Hz in Europe, Australia, most of South America, Africa and Asia, and New Zealand it's 230V at 50 Hz.
INPUT: AC 120V 60Hz OUTPUT: DC 12V 200mA