answersLogoWhite

0

Yes but the four center (two on each side) intake manifold bolts will need to be elongated as the older heads had the the holes at and angle and the newer go straight down.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

1997 dodge ram 1500 5.0 engine block heater location?

1997 dodge ram 1500 2wd 1500 engine block heater location


Can you use a 1997 350 short block with 1992 350 cylinder heads?

yes, you can use those heads. the block does have small changes to it but no problm will occur


How do you make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads?

To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.


How do you put lifters in a 1997 Dodge 1500?

You have to remove the cylinder heads to access the lifters. I suggest you by a service manual before attempting.


Will a 1994 Chevy Blazer engine fit into a 1997 Chevy Blazer?

DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL


Where is the freeze plug located on a 1997 Jimmy 6-cylinder?

there are usually several in the engine block just below the cylinder heads. most are round or oval, and are recessed into the block.


Will a fuel pump out of a 1988 c-1500 fit in a 1997 S-10?

no, they are different and pump different fuel pressures.


What are the ratings and certificates for Sleepy Heads - 1997?

Sleepy Heads - 1997 is rated/received certificates of: USA:R


Reset ecm on a 1997 chey silverado 1500?

just unscrew the battery terminal by 1 minute, or take off the fuse of the block panel for the same time


1997 Chevy 1500?

...what about it?


When was Cooler Heads Coalition created?

Cooler Heads Coalition was created in 1997.


Will 1995 Chevrolet 350 intake fit a 1997 vortec heads?

will 1995 Chevrolet 350 intake fit a 1997 vortec heads