yes
It depends on the rms of the two cvrs combined. Also if the 1200 watt amp is 1200 watt rated (rms) or 1200 watt peak. Lets say the two kickers have an rms of 600 watt each, and the amp is 1200 watt rms, which it probably isnt but i'll pretend. This set up would work because 600 of the amps watts would be correctly matched with one sub, and the other 600 would go to the other sub.
It will, but only 1.75 decibels louder. The smallest change in loudness that most people can detect is 1 decibel, so the difference between 400 and 600 watts would be barely noticeable.
NONE! 600 watts is nothing you don't need one, but if you insist, one 1 farad would fix you.
yes it can
Voltage times amps equals watts. A watt is sometimes called a volt-amp because one volt times one amp equals one watt.
They can be as loud, as the amp is not delivering 600 watts. The 10" sub rated at 600 watts is able to withstand more power.
Absolutely!! If you turn up the gain too much, the speakers will smoke. You can use it at a lower level
can a 500 watt solar panel run a 500 watt appliance with 2 102 amp deep cycle batteries
It depends on the rms of the two cvrs combined. Also if the 1200 watt amp is 1200 watt rated (rms) or 1200 watt peak. Lets say the two kickers have an rms of 600 watt each, and the amp is 1200 watt rms, which it probably isnt but i'll pretend. This set up would work because 600 of the amps watts would be correctly matched with one sub, and the other 600 would go to the other sub.
nope your powering it just right
It will, but only 1.75 decibels louder. The smallest change in loudness that most people can detect is 1 decibel, so the difference between 400 and 600 watts would be barely noticeable.
All car speakers will go well with a 500 Watt amp, but for the best effect, get a power subwoofer.
sure. Will it be loud? No. Its just not enough power to drive that sub.
Yes the amp can push the 2 subs. I have 2 1250 watt 12inch subs and 1 maybe 400 or 500 watt amp and the amp does fine but if you want more bass at lower levels of volume then you want to have a bigger amp. Just make sure your amp doesnt blow your subs.
you ohm load is too low. raise the ohm load or buy an amp that is stable at the ohm level of the sub.
No, the current will be too high.
a 500 watt sub woofer puts out 250 RMS a 500 watt amp puts out the same and if you want a good setup get a sub with RMS and a amp with 1200 max so 600 RMS will be powering the same 500 RMS sub woofer then you can tune it to push the sub woofer a bit and the sub woofer should take it I recommend ether mono single channel 2 channel brands go name brand if u want support later or go no name to be different