Yes the amp can push the 2 subs. I have 2 1250 watt 12inch subs and 1 maybe 400 or 500 watt amp and the amp does fine but if you want more bass at lower levels of volume then you want to have a bigger amp. Just make sure your amp doesnt blow your subs.
get the 2800
yeah it is i had 2 12s and 2 10s hooked up to a 900 watt amp and it hit hard
It depends on the specific power-handling capabilities of the subwoofers and their impedance. If the subwoofers have a total power handling capacity that is lower than 300 watts and the amplifier can provide enough power at the required impedance, then it should be able to adequately power the two tens. However, if the subwoofers have a higher power handling capacity or the amplifier cannot provide enough power, it may not be sufficient.
A Rockford 250 watt amp would compliment a 12" Subwoofer very nicely.
Depends on the size of the amplifier you are installing and the power required to run it. You can easily install a 500 watt amp with no problems.
To power two 300 watt subwoofers, you will need an amplifier with a maximum power output of at least 600 watts. It is recommended to choose an amplifier with a slightly higher wattage rating to ensure that the subwoofers receive enough power for optimal performance.
Yes
Find out what the rms is for that sub woofer,if it'1000 then find out what the max is,then you could go between the rms power and the max power to get the right amount of watts.
No thanks...I got a nice 4000 watt system.
There are a bunch of important factors to consider prior to buying an amplifier for a vehicle. Primarily, you must decide what the amplifier will be primarily used for. If the amplifier will be used for powering subwoofers it would be good to consider the bridged or mono capabilities as well as ohm ratings of the amplifier as well as the draw, or amount of power the amplifier will pull from the car's electrical system. The most important factor in considering an amplifier for powering subwoofers is probably output watts, which will determine the amplifier's power to the speakers and the amount of bass to be transmitted. If the amplifier is to be used to power mid or high range speakers, a multi channel (four or more) amplifier should be considered because of the ability to run multiple sets of speakers or component sets off of the different channels of the amplifier. The considerations inherent to the subwoofer amplifier are also present including watt ouput and power draw, but when selecting a multi cha
yes/no
No the Lanzar MAXP64 Max Pro 6.5-Inch 600-Watt Small-Enclosure subwoofers are very small.