NO ! - woodstain does not use a primer.
NONE - just use woodstain.
There are many good latex primers that will work under oils.
Most stains, be they latex or oil based are transparent or semi-transparent, using a primer under it would eliminate the possibility of seeing the wood beneath the stain (which is usually why stain is used).A primer is used over oil based paint when you want to switch over to use latex based paint on the same surface.
All the information I read on Tinners paint refers to it as 'anti-rust' exterior metal paint . - I certainly wouldn't put a latex primer on anything outside. I would use Kilz original as a primer.
paint it with a universal primer such as "BLOCKER" brand first Yes, you can. My preference is to use oil base primer under latex (water base) paint, because in my experience the oil base primer lasts longer. It stays stuck to the wood longer. I think latex primer is basically bogus. I have wasted a lot of time using latex primer and it comes loose and I have to sand it all off and use oil base primer. Latex primer does not work. Just like latex paint sticks poorly to bare wood. Latex paint does not have much "stick" (also called "tack"). It is a thin sheet of rubber, and there is very little "tack" to it to keep it glued to the wood. Latex peels off readily, once you put a knife under an edge.
Latex paint can be used as a primer but the results may not be what you want. Primer is less expensive than latex paint and has special qualities that create a seal and help the finish layer of paint adhere better. In the long run you will save time and money by using the correct product for the job.
In most cases yes. Primer is applied according to what it is going on, not what is going over it. - Latex / acrylic / water-based primers are good over drywall, stucco, brick, patches and repairs made with polyfil or other drywall patching compounds, paper, and many other porous materials. Once the primer is applied and dry any type of paint may be painted over it.
Yes, the water borne latex paint manufactured today can be covered successfully with nearly any finish imaginable, including an alkyd primer. However, if possible I would exchange the alkyd with any water base primer/sealer. Costs less and the fumes aren't as offensive.
i want to no what it cost for kids and adults to get in cedar point
Most people staining a cedar deck tend to use a semi-transparent stain. If this is what you intend to use, then NO. Primers are intended to hide the surface under them. What you should be concerned with is the wood itself, in order to get the very best result, be absolutely certain the wood is completely dry.
This depends in large part on what paint or finish your are going to cover your oil-finish with. First, you need to determine, if possible, if your existing oil paint contains lead. If the oil paint is over 30 years old, you should assume that it has lead and the paint should be removed before continuing. (See your local codes). If you are painting the surface with an oil-based paint, simply rough up your surface with 220-grit sandpaper, clean and paint away. If you are covering your finish with latex, you should scuff the finish with 220-grit sandpaper, clean it well and apply two coats of latex primer before applying your final coats of paint. If you are applying wallpaper, we suggest that you scuff up your oil finish, apply two coats of latex primer and allow it to dry for at least 3 days before papering.
Primer is under the paint.