No, you cannot. The plastic pipe will crack creating a damaged and burst pipe. Only metallic type pipes are to be used when using such a clamp.
If it is a pipe that is not easily cut out and replaced, you can use a pipe clamp. Wrap the clamp around the pipe and tighten the two bolts to compress it around the pipe. If it is a drain pipe as you say, there is very little pressure on t he line, so the clamp should work fine.
Cast iron drainage pipe with neoprene gaskets and clamp. See plumbing.1800anytyme.com/plumbing-glossary.php
It is never advisable to use clamp lights with heating bulbs on plastic cages, as it might start a fire. Please use glass, or metal cages for these type of applications.
if it's plastic pipe you can just buy a glue cap and glue it on. If it's galvanized or cast iron pipe you can use a gym cap, (arubber cap that comes with a hose clamp). Just put that on the pipe and tighten it down firmly. this will prevent any sewer gas from coming out of the drain.
A couple large hose clamps and a peice of inner tube or you can use same diameter pipe and clamp in between where the split is. If it's hard plastic maybe bondo or a fibreglass patch.
I just use a hacksaw.
no, they use a small plastic clamp and then cut chord after clamp. clamp stays on until chord dries up and falls off.
car,door,decoration materials,Plastic pipe and so on
You don't. You use preformed elbows.
You can put up to a 2 inch pipe into a 4 inch. If you are putting 4 inch to 4 inch, either take out a section of the cast and put the PVC in or cut out a section and connect the PVC to the cast with rubber sleeves meant for this. You can use a saddle clamp for the 2 inch. It is a half round piece of PVC with a 2 inch connection in it. It is held on with two U bolts that go around the cast pipe. Put it where you need it and mark the 2 inch hole on the cast. Drill a series of 1/8 inch holes around this circle. when you get them all drilled, you can break out the plug. Try to keep it from falling into the cast pipe. Put the saddle clamp on and connect the PVC pipe as needed. Seal the saddle clamp to the cast pipe with plumbers putty.
Yes, you can join plastic pipe to metal pipe. However, the bigger question is "will my local building code allow me to do this?" and also is it safe to do it. To answer that question, please consult a local contractor or handyman in your area.
Black plastic pipe is ABS -Use yellow ABS cement. -I don't understand "grey bard fitting" -Take this to your plumbing store and they will advise.Black plastic pipe is ABS -Use yellow ABS cement. -I don't understand "grey bard fitting" -Take this to your plumbing store and they will advise.