Yes , but on a very small motor. Check the specs. of the dimmer as most will tell you how much they can be loaded to.
The LDR dependent AC dimmer is a Light Dependent Resistor which works by chopping off the parts of the AC voltage.
Although a dimmer can be designed for 12 v halogen lamps it is more common for dimmers to work on higher voltages. Dimmers have to work into a resistive load so it is not usually possible to place the dimmer on the high-voltage side of the 12 v transformer that comes with the lights.
A dimmable eco bulb may not dim when controlled from a dimmer switch because it is not compatible with the type of dimmer switch being used. Some dimmer switches require specific types of bulbs or have specific voltage requirements that may not be met by the bulb. It is important to ensure that the dimmer switch and bulb are compatible for proper dimming functionality.
Dimmerstat is the device with ac input an ac output. it consist of a variable transformer inside it so as to vary the output.
Yes , but on a very small motor. Check the specs. of the dimmer as most will tell you how much they can be loaded to.
The output of a 120 volt dimmer switch will be an AC voltage so should not be used on a DC motor.
how do you change a ac fan switch on a 1997 Chevy cavalier
use a piece of duct tape and wrap the clutch assembly
does fan door motorized or on a vaccuum line when you switch from AC to defrost?
Most likely either the switch or the motor is defective.
The LDR dependent AC dimmer is a Light Dependent Resistor which works by chopping off the parts of the AC voltage.
replace the switch
If you mean the compressor, then it could be: A blown fuse, bad AC switch, or low freon. If you mean the blower fan, same problems above, but add a bad fan switch, or regulator.
Generally, on most vehicles, the radiator fan is controlled by a thermostatic/electric switch. When the coolant temperature rises to the setpoint, the switch closes, applying electric current to the fan, turning it on. Then, when the coolant temprature has cooled below the setpoint, the switch opens, turnng the fan off.
You have a short in the wiring or switch. Use either an ohm or multi meter to trace it out. Start at the switch and work back toward the fan fuse connection.
what is a ac relay on a car ac relay switch turns the ac fan on and off depending on the temp of the freon too cold it turns off too warm it turns on depends on the preset temp