Yes, busbars can be used on satellites just like it is used for ground use. But, it should be space qualified..
Yes, through the use of global positioning systemsscientists use satellite data to predict earthquakes.
Aryabhatt satelite was use in communication
Satellites operate through the use of gravity because the force of gravity on the satellite results in circular motion around the earth or any other celestial body, and if that force was too big it would cause the satellite to come crashing down and if it were too small the satellite would just go flying off into space
satellite is satellite
the government can, in fact, take aerial satellite photos. generally they are of streets and highways for cataloging or for use in GPS.
Aspacecraft/Satellite
To obtain the amp of the copper bus bar, multiply the width of the bus bar by the thickness of the bus bar to obtain the current carrying capacity of the bus bar.
Bus coupler is use to separate the main bus and reserve bus bar while the bus tie is used for paralleling and syncronizing.
5-6x150 Cu. BUS BAR PER PHASE
Single bus is used in smaller, less important substations. A fault on the bus requires tripping of all lines into the bus. When higher redundancy is necessary, ring and breaker and 1/2 schemes are used. These are the three most common.
The term "bus bar" refers to a strip of bar of brass, aluminum, or copper. This strip of bar conducts electricity with a distribution and switch board.
Most busbars are copper with a tin plating to protect from corrosion.
Bus bar is a physical component that carries the current. AMP is unit of current. They can not be converted
...because it is an infinite bus bar, meaning it can supply infinite current. By Ohm's law, since the voltage at the bus bar is fixed, to have infinite current, you must have a zero impedance.
Bus bars are actually simple conductor strips of copper using for connection between one system to another.for example transformer to panel. bus ducts are enclouser of that bus bar
voltage of incoming machine should be same as that of bus bar voltage
busbar sizing & calculation